Sears 917.258542 owner manual Operation, To Move Forward and Backward

Page 12

OPERATION

'

i,

ii

i

ii

.....ii

,i .......

The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend a wide vision safety mask over the spectacles or standard safety glasses.

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE (See Fig. 9)

Your tractor is equipped with an operator presence sensing switch., When engine is running, any attempt by the operator to leave the seat without first setting the parking brake witl shut off the engine.

. Depress clutch!brake pedal into full "BRAKE" position and hold.

. Place parking brake fever in "ENGAGED" position and release pressure from clutch/brake pedal Pedalshould

remain in "BRAKE" position., Make sure parking brake will hold tractor secure.

ATTACHMENT

CLUTCH LEVER

"ENGAGED"

POSITION

THROTTLFJCHOKE

 

CONTROL -_._

"DISENGAGED"

 

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause "browning" of grass, To eliminate this possibility, always stop engine when stopping tractor on grass areas,,

pletely, as described above, before leav- CAUTION:ing the operator'sAlways position;stop tractor emptycom- grass catcher, etco

TO USE THROTTLE CONTROL (See Fig, 9)

AEways operate engine at full throttle,

=Operating engine at less than full throttle reduces the battery charging rate

oFull throttle offers the best bagging and mower perfor- mance.

PARKING BRAKE

"ENGAGED"

"BRAKE"GEARSHIFT

POSITION

"DISENGAGED" POSITION

CLUTOH/BRAKEHEIGHT ADJUSTMENT

PEDAL "DRIVE"KNOB

POSITION

FIG, 9

STOPPING (See Fig. 9)

MOWER BLADES -

•Move attachment clutch lever to "DISENGAGED" po- sition.

GROUND DRIVE -

•Depress clutch/brake pedal into full "BRAKE" position,,

. Move gearshift lever to neutral (N) position.

ENGINE -

• Move throttle control to stow (_) position.

NOTE: Failure to move throttle control to slow (,_) position and allowing engine to idle before stopping may cause engine to "backfire".

•Turn ignition key to "OFF" position and remove key.

Always remove key when leaving tractor to prevent unauthorized use.

°Never usa choke to stop engine_

TO MOVE FORWARD AND BACKWARD

(See Fig. 9)

The direction and speed of movement is controlled by the gearshift lever,.

oStart tractor with clutch/brake pedal depressed and gearshift lever in neutral (N) position,.

•Move gearshift lever to desired position.

-Slowly release clutch/brake pedal to start movement.

IMPORTANT: BRING TRACTOR TO A COMPLETE STOP BEFORE SHIFTING OR CHANGING GEARS+ FAILURE TO DO SO WILL SHORTEN THE USEFUL LIFE OF YOUR TRANSAXLE

TO ADJUST MOWER CUTTING HEIGHT (See Fig. 9)

The cutting height iscontrolled by turning the height adjust- ment knob in desired direction_

•Turn knob clockwise ((_) to raise cutting height,

°Turn knob counterclockwise (_e'-_'_)tolower cutting height.

The cutting height range is approximately 1-1/2" to 4" The heights are measured from the ground to the btade tip with the engine not running. These heights are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

=The average lawn should be cut to approximately 2-1/2 inches during the cool season and to over 3 inches during hot months,, For healthier and better looking lawns, mow often and after moderate growth,

°For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut relatively high; the second to desired height

12

Page 11 Page 13
Image 12
Page 11 Page 13
Contents Model Number 917.258542 Ownersmanual For Consumer Assistance HOT LINE, Call this Toll Free NumberSafe Operation Practices for Ride-On Mowers III. ChildrenMaintenance Agreement Index Engine Maintenance AttachmentsPerformance Contents Hardware Parts Bag contents shown ful! sizeParts bag contents not shown full size PackConnect Battery See Figs Assemble Extension Shaft and BootInstall Steering Wheel Unpack CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemAssembly Install Mulcher Plate See FigsTo Convert to Bagging or Discharging Shoulder BoltOperati Operation Know Your TractorOperation To Move Forward and BackwardOPERAT!O To Operate Mower See FigTo Transport To Operate on HillsTo Start Engine See Fig Mulching Mowing TipsLubrication Chart CustomerBefore Each USE Battery TractorBrake Operation TiresCustomer LubricationClean AIR Screen Clean AIR INTAKE/COOLINGCusto ResponEngihe OiL Filter See Fig IN-LINE Fuel Filter See FigAdjustments To Install Mower See FigTo Remove Mower See Fig If AN Attachment Other thanRvice AN Adjustments To Level Mower HousingAdjust the mower while tractor is parked on level ground or To Adjust Brake See Fig To Replace Mower Blade Drive BeltTo Replace Motion Drive Belt With Parking Brake EngagedService To Adjust Steering Wheel AlignmentTransaxle Shifter Linkage and AD- Justment See Figs Front Wheel TOE-IN/CAMBERService AdjustmentsTo Replace Fuse To Replace Headlight BulbService Adjustments To Adjust Throttle Control CableTo Adjust Carburetor See Fig Acceleration TestFuel System Engine OILCylinders Troubleshooting Points ProblemCause Correction Troubleshooting Points ProblemcauseCorrection SEA,SW,TOH PoSmONOptional LineElectrical KEY Part NO, NO, DescriptionUNC Chassis and Enclosures CHASS1SANDENCLOSURES KEY Part DescriptionStlt 88 87 121Drive STLSteering Assembly FF224035X Repair Parts Seat AssemblyDecals 151300Wheels & Tires Engine Optional Equipment Spark ArresterREPAmR Parts Tractor --MODEL Number Mower Lift 549150 \ 161718Mower Lift KEY Part NO. noMower Deck 105113 111 114 Mower Deck KEY Part Torsion BrakesTUV Peerless Transaxle Model Number 930-057A Part REF Part Description 792075Blower Housing Baffles Kohler Engine Model Number CV15S, Type Number PS-41526AIR Intake Engine Controls JBlower Housing and Baffles KEY Part Description AIR Intake Engine Controls KEY Part NO. noCrankshaft KEY Part Description KEY Part NO. noKohler ENGINE- Model Number CV15S, Type Number PS-41526 Cylinder HEAD, Valve and Breather2227 Not Illustrated OIL PAN / Lubrication J Ignition ELECTRICAL,,IStarting System 231Ignition Electrical KEY Part Description Not IllustratedOIL PAN 1 Lubrication Crankcase KEY Part NO. noPage ItA OporaoyourTupanO0owntheaceosocornotI Owners ManualINFORMATION Following Information

917.258542 specifications

The Sears 917.258542 is a notable model in the world of outdoor power equipment, specifically engineered for lawn care enthusiasts and homeowners seeking reliable performance. This lawn mower is recognized for its robust design and a plethora of features that make lawn maintenance a straightforward task.

One of the standout characteristics of the Sears 917.258542 is its powerful engine. Equipped with a reliable Briggs & Stratton engine, it delivers excellent cutting performance, allowing for efficient grass cutting across different terrains. The engine is designed for easy starting and durability, ensuring that users can rely on it season after season.

The cutting deck is another key feature, typically ranging from 20 to 21 inches, making it suitable for both small and medium-sized lawns. The deck design allows for efficient grass clipping with multiple height adjustment settings. This adjustability lets users maintain their lawn at the desired height, fostering a healthier yard. Furthermore, the mower's deck may come with a mulching feature, which is particularly beneficial for returning nutrients back to the soil.

Innovation is imbued within the Sears 917.258542 through its user-friendly controls. Operators can easily adjust the speed and cutting height, providing customizable performance tailored to individual needs. The mower's ergonomic design enhances comfort during operation, reducing fatigue during extensive mowing sessions.

Another important technology incorporated in the Sears 917.258542 is its self-propulsion system. This feature allows users to navigate the mower across varied landscapes without excessive physical exertion. The self-propelling mechanism streamlines mowing, allowing the mower to advance at a pace controlled by the user.

Durability has not been overlooked in this model. Made with high-quality materials, the Sears 917.258542 is built to withstand the rigors of regular use, including harsh weather conditions. Maintenance is simplified with easy access to the air filter and spark plug, which helps to prolong the life of the mower.

In conclusion, the Sears 917.258542 emerges as a reliable and efficient solution for lawn care. Its powerful engine, adjustable cutting deck, user-friendly controls, self-propulsion feature, and durable construction make it an intelligent choice for anyone looking to keep their lawn in pristine condition. Whether battling tall grass or maneuvering around obstacles, this mower is designed to meet the diverse needs of home lawn care.
Top Page Image Contents