McCulloch M19542H manual To Level Mower, Visual SIDE-TO-SIDE Adjustment See Fig

Page 21

SERVICE AND ADJUSTMENTS

TO LEVEL MOWER

Make sure tires are properly inflated to the PSI shown on tires. If tires are over or under inflated, it may affect the appearance of your lawn and lead you to think the mower is not adjusted properly.

VISUAL SIDE-TO-SIDE ADJUSTMENT (See Fig. 20)

•With all tires properly inflated and if your lawn appears unevenly cut, determine which side of mower is cutting lower.

•With a 3/4" or adjustable wrench, turn lift link adjust- ment nut (A) to the left to lower LH side of mower, or, to the right to raise LH side of mower.

 

A

Turn nut right

Turn nut left

to raise mower

to lower mower

02948

 

FIG. 20

NOTE: Each full turn of adjustment nut will change mower height about 3/16".

•Test your adjustment by mowing some uncut grass and visually checking the appearance. Readjust, if necessary, until you are satisfied with the results.

PRECISION SIDE-TO-SIDE ADJUSTMENT (See Fig. 21)

•With all tires properly inflated, park tractor on level ground or driveway.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to its highest position.

•At both sides of mower, position blade at side and measure the distance (A) from bottom edge of blade to the ground. The distance should be the same on both sides.

 

02966

A

A

FIG. 21

•If adjustment is necessary, see step in Visual Adjust- ment instructions above.

•Recheck measurements, adjust if necessary until both sides are equal.

FRONT-TO-BACK ADJUSTMENT (See Figs. 22 & 23) IMPORTANT: Deck must be level side-to-side.

To obtain the best cutting results, the mower blades should be adjusted so the front tip is 1/8" to 1/2" lower than the rear tip when the mower is in its highest position.

CAUTION: Blades are sharp. Protect your hands with gloves and/or wrap blade with heavy cloth.

•Raise mower to highest position.

•Position any blade so the tip is pointing straight forward. Measure distance (B) to the ground at front and rear tip of the blade.

02548

BB

FIG. 22

•If front tip of blade is not 1/8" to 1/2" lower than the rear tip, go to the front of tractor.

•With an 11/16" or adjustable wrench, loosen jam nut A several turns to clear adjustment nut B.

•With a 3/4" or adjustable wrench, turn front link adjust- ment nut (B) clockwise (ltighten) to raise the front of mower, or, counterclockwise (loosen) to lower the front mower.

B

A

TIGHTEN ADJUST

LOOSEN

ADJUST NUT

NUT B TO RAISE

B TO LOWER

MOWER

 

02950

MOWER

 

LOOSEN JAM NUT A FIRST

 

FIG. 23

NOTE: Each full turn of the adjustment nut will change mower height about 1/8".

•Recheck measurements, adjust if necessary until front tip of blade is 1/8" to 1/2" lower than the rear tip.

•Hold adjustment nut in position with wrench and tighten jam nut securely against adjustment nut.

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Model NO. M19542H 19.5 HP 42 Inch Lawn Tractor Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationGeneral Service ServiceIII. Children IV. TowingTable of Contents Contents of Hardware Pack Tools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck Battery See Fig Install Seat See FigCheck Deck Levelness Check Tire PressureCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Reverse Operation System ROS Using the Reverse Operation SystemTo Operate on Hills To Operate Mower See FigTo Transport Before Starting the EngineTowing Carts and Other ATTACH- Ments Check Engine OIL LevelMowing Tips Purge TransmissionAutomatic Transmission Warm UP Lubrication Chart MaintenanceBattery TractorBlade Removal See Fig Engine Transaxle MaintenanceBelts Transaxle CoolingCleaning Service and Adjustments To Install Mower See FigTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower Visual SIDE-TO-SIDE Adjustment See FigTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Replace Motion Drive Belt See Fig To Adjust Steering Wheel ALIGN- Ment Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILProblem Cause Correction Troubleshooting PointsEngine dies when Service Notes Service Notes Service Notes Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe Operation

M19542H specifications

The McCulloch M19542H is a robust and versatile lawn mower designed to cater to the needs of both residential and professional users. This high-performance machine boasts a combination of advanced technology and user-friendly features, making it a top choice for tackling various mowing tasks.

One of the standout features of the M19542H is its powerful 195cc engine. This engine is designed to provide exceptional torque and cutting power, enabling the mower to handle thick grasses and uneven terrains with ease. The reliable starting system ensures that users can begin their mowing sessions without the frustration of difficult starts, allowing for a smooth and efficient operation.

The mower is equipped with a wide 42-inch cutting deck, which not only allows for quick mowing of larger areas but also provides an adjustable cutting height. This feature grants users the flexibility to choose from several cutting heights, ensuring the perfect lawn finish whether aiming for a manicured look or a more natural appearance.

Another notable characteristic of the McCulloch M19542H is its innovative twin-blade system. This design enhances cutting efficiency, producing finely mulched grass clippings that can be recycled back into the lawn. This not only improves the overall health and appearance of the lawn but also reduces the amount of waste generated during the mowing process.

Comfort is paramount in the design of the M19542H. The adjustable ergonomic handle ensures that users can maintain a comfortable grip and posture while mowing, reducing fatigue during prolonged use. Additionally, the mower features a compact and maneuverable design, allowing for easy navigation around obstacles and tight spaces.

Safety is also a key consideration in the design of the McCulloch M19542H. The mower is equipped with various safety features, including a blade brake that stops the mower's blades when the user releases the handle, ensuring peace of mind during operation.

In terms of maintenance, the M19542H is designed for convenience. The easy-access oil and air filters make routine checks and replacements simple, promoting optimal performance longevity. Overall, the McCulloch M19542H combines power, efficiency, and user-friendly design, making it an excellent choice for anyone looking to maintain a pristine lawn with minimal effort.
Top Page Image Contents