McCulloch MC195H42LT manual To Adjust Seat See Fig, Check Tire Pressure, Check Deck Levelness

Page 7

ASSEMBLY

SEAT

SWITCH

PAD

SLOT

SEAT

PAN

TAPE

WIRING HARNESS

Fig. 3

TO ADJUST SEAT (See Fig. 4)

Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.

SLOT

 

TAPE

PAD

 

 

FLAT

 

 

WASHER

 

 

SEAT PAN

 

BOLT

TAB

ADJUSTMENT

HANDLE

 

 

Fig. 4

NOTE: You may now roll your tractor off the skid. Follow the instructions below to remove the tractor from the skid.

WARNING: Before starting, read, understand and follow all instructions in the Operation section of this manual. Be sure tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

•Raise attachment lift lever to its highest position.

•Releaseparkingbrakebydepressingclutch/brakepedal.

•Place freewheel control in "transmission disengaged position" (See “TO TRANSPORT” in the Operation section of this manual).

•Roll tractor forward off skid.

•Remove banding holding the deflector shield up against tractor.

Continue with the instructions that follow.

CHECK TIRE PRESSURE

The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance.

•Reduce tire pressure to PSI shown on sides of tires.

CHECK DECK LEVELNESS

For best cutting results, mower housing should be prop- erly leveled. See “TO LEVEL MOWER HOUSING” in the Service and Adjustments section of this manual.

CHECK FOR PROPER POSITION OF BELTS

See the figures that are shown for replacing motion and mower blade drive belts in the Service and Adjustments sec- tion of this manual. Verify that the belts are routed correctly.

CHECK BRAKE SYSTEM

After you learn how to operate your tractor, check to see that the brake is operating properly. See “TO CHECK BRAKE” in the Service and Adjustments section of this manual.

✓CHECKLIST

BEFORE YOU OPERATE YOUR NEW TRACTOR, WE WISH TO ASSURE THAT YOU RECEIVE THE BEST PERFORMANCE AND SATISFACTION FROM THIS QUALITY PRODUCT.

PLEASE REVIEW THE FOLLOWING CHECKLIST:

✓All assembly instructions have been completed.

✓No remaining loose parts in carton.

✓Battery is properly prepared and charged.

✓Seat is adjusted comfortably and tightened securely.

✓All tires are properly inflated. (For shipping purposes, the tires were overinflated at the factory).

✓Be sure mower deck is properly leveled side-to-side/ front-to-rear for best cutting results. (Tires must be properly inflated for leveling).

✓Check mower and drive belts. Be sure they are routed properly around pulleys and inside all belt keepers.

✓Check wiring. See that all connections are still secure and wires are properly clamped.

✓Before driving tractor, be sure freewheel control is in “transmission engaged” position (see “TO TRANS- PORT” in the Operation section of this manual).

WHILE LEARNING HOW TO USE YOUR TRACTOR, PAY EXTRA ATTENTION TO THE FOLLOWING IMPORTANT ITEMS:

✓Engine oil is at proper level.

✓Fuel tank is filled with fresh, clean, regular unleaded gasoline.

✓Become familiar with all controls, their location and function. Operate them before you start the engine.

✓Be sure brake system is in safe operating condition.

✓Be sure Operator Presence System and Reverse Op- eration System (ROS) are working properly (See the Operation and Maintenance sections in this manual).

✓It is important to purge the transmission before operat- ing your tractor for the first time. Follow proper start- ing and transmission purging instructions (See “TO START ENGINE” and “PURGE TRANSMISSION” in the Operation section of this manual).

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Operators Manual II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationIV. Towing ServiceGeneral Service III. ChildrenTable of Contents Steering Wheel Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck for Proper Position of Belts To Adjust Seat See FigCheck Tire Pressure Check Deck LevelnessOperation ROS on Know Your TractorPosition To USE Throttle Control See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Operate Mower To Adjust Mower Cutting Height See FigTo Adjust Gauge Wheels See Fig Reverse Operation System ROSADD Gasoline To Operate on HillsTowing Carts and Other Attachments Before Starting the Engine Check Engine OIL LevelPurge Transmission Mowing TipsAutomatic Transmission Warm UP Schedule MaintenanceMaintenance General RecommendationsTractor BatteryBlade Removal See Fig Engine Muffler Clean AIR ScreenCleaning AIR FilterTo Install Mower See Fig Service and AdjustmentsTo Remove Mower See Fig Install belt on engine pulley M, in belt keepers G To Level Mower To Replace Motion Drive Belt See Fig Belt InstallationTo Replace Mower Blade Drive Belt See Fig To Check BrakeFront Wheel TOE-IN/CAMBER Transaxle Motion Control Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig To Adjust Steering Wheel AlignmentTransmission Engine OIL StorageOther Fuel SystemProblem Cause Correction TroubleshootingTroubleshooting Points Only Ride UP and Down Hill Not Across Hill Degrees MAX Suggested Guide for Sighting Slopes for Safe OperationLimited Warranty

532 43 25-35, 96042011400, MC195H42LT specifications

The McCulloch MC195H42LT is a versatile lawn tractor designed for homeowners looking for a reliable and efficient machine to maintain their lawns. This tractor is particularly noteworthy for its blend of power, precision, and user-friendly features, making it a great choice for both novice and experienced users.

One of the standout features of the MC195H42LT is its powerful engine. It is equipped with a robust 532cc engine that provides ample power for tackling various lawn care tasks. The engine operates smoothly and starts easily, ensuring that users can get to work without hassle. The mowing deck, measuring 42 inches, is designed for efficient cutting, allowing for faster mowing times while delivering a clean and precise cut.

In terms of technology, the McCulloch MC195H42LT includes a hydrostatic transmission system. This system allows for seamless speed adjustments without the need for manual gear shifting. The result is a smooth driving experience and improved maneuverability on different terrains. Additionally, the tractor features a turning radius that makes it easy to navigate around trees, flower beds, and other obstacles in the yard.

The comfort of the operator is also a priority in the design of the MC195H42LT. It comes with an adjustable seat, ensuring that users of varying heights can find a comfortable driving position. This is complemented by easy-to-access controls that allow for effortless operation of the tractor's functions, such as cutting height adjustments.

Another important characteristic is its ease of maintenance. The design of the lawn tractor includes features that simplify routine care, enabling users to spend more time mowing and less time on upkeep. For those looking to enhance their lawn care experience, there are additional accessories available, such as towing carts and mulching kits.

Overall, the McCulloch MC195H42LT is a well-rounded lawn tractor that offers a powerful engine, user-friendly technology, and comfort for the operator. Its design effectively meets the demands of homeowners seeking an efficient and reliable machine for maintaining their lawns while also providing options for customization and enhanced functionality.
Top Page Image Contents