Manuals / Pioneer / Home Audio / Stereo Receiver

Pioneer VSX-41 manual Additional information, Troubleshooting, Problem, Adjust the MASTER VOLUME

Models: VSX-41

1 72

Download 72 pages 20.23 Kb

Page 67

Additional information

Additional information

10

Troubleshooting

Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Investigate the other components and electrical appliances being used. If the trouble cannot be rectified even after exercising the checks listed below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.

Problem

Remedy

The power does not turn on.

•Connect the power plug to the wall outlet.

•Disconnect the power plug from the outlet, and insert again.

•Make sure there are no loose strands of speaker wire touching the rear panel. This could cause the receiver to shut off automatically.

No sound is output when a function is selected.

•Make sure the component is connected correctly (refer to pages 13–18).

•Press MUTE on the remote control to turn muting off.

•Adjust the MASTER VOLUME.

•Press the MONITOR button to turn monitoring off.

No image is output when a function is selected.

•Make sure the component is connected correctly (refer to pages 13–18).

•Select the correct component (use the MULTI JOG/INPUT SELECTOR dial or the MULTI CONTROL buttons on the remote).

Considerable noise in radio	• Tune in the correct frequency.
broadcasts.	• Connect the antenna (refer to page 18).
	• Route all cables away from the antenna terminals and wires.
	• Fully extend the FM wire antenna, position for best reception,
	and secure to a wall.
	• Connect an outdoor FM antenna (refer to page 18).
	• Adjust the direction and position for best reception.
	• Connect an additional internal or external AM antenna (refer
	to page 19).
	• Turn off the equipment causing the noise or move it away from
	the receiver.
	• Place the antenna farther away from the equipment causing
	the noise.

Broadcast stations cannot be	• Connect an outdoor antenna (refer to page 18).
selected automatically.

67

En

Image 67

Pioneer VSX-41 manual Additional information, Troubleshooting, Problem, Adjust the MASTER VOLUME

Contents

AUDIO/VIDEO MULTI-CHANNELRECEIVER VSX-41Operating Instructions IMPORTANT NOTICE trademarks of Dolby Laboratories “Dolby”, “Pro Logic” and the double D symbol are1 Before you start Contents3 Connecting up 6 Setting up your receiver10 Additional information 7 Using the tuner8 Making a recording 9Controlling the rest of your systemMaking cable connections Installing the receiverOperating range of remote control unit 01Before you start Checking what’s in the boxIntroduction to home theater 5 minute guide1 Hook up your DVD player 02 5 minute guide Listening to Surround Sound2 Hook up your TV 3 Connect your speakers 5 minute guideSurround back speaker or subwoofer 02 5 minute guide5 minute guide 6Play a DVD, and adjust the volume to your likingsize 4.0ch 025 minute guide Using the Quick Setup3.0ch 3.1chComponent video cords Connecting upAudio/Video cords VIDEO S-videocablesSatellite tuner CD recorder CD player 03 Connecting up Connecting digital componentsDVD player Connecting up Connecting audio componentsCD player CD-R/Tape/MDDeck Connecting DVD 7.1 channel components 03 Connecting upConnecting video components Video deck Connecting to the front panelvideo terminal Connecting upAntenna snap connectors 03Connecting up Connecting antennasFM wire antenna Using external antennasConnecting up Connecting the speakersA and B speaker systems 03Connecting upHints on speaker placement Speaker terminalsCenter Connecting upOverhead view of speaker set up 3-Dview of speaker set upSurround back channel amplifier 03 Connecting up Connecting additional amplifiersFront channel amplifier Surround channel amplifierConnecting up POWER-CORDCAUTIONAC wall outlet Operating other Pioneer components04Controls and Displays Front panel Display Controls and Displays04Controls and Displays Controls and Displays Remote control 5 MULTI CONTROL buttons 04Controls and DisplaysDTV MENU Controls and DisplaysPro Logic 05Playing sources Introduction to Sound ModesStereo/Direct Standard modeExpanded Playing sourcesAdvanced Surround modes Virtual Surround Back VIRTL SB3Press STANDARD 05Playing sources Choosing the input signalListening to multichannel playback 1Switch on the playback componentII Music Using Stereo/DirectUsing Advanced Surround Using Loudness and Midnight listening1Turn on the power of the playback component 05Playing sources Using the tone controlsPlaying other sources Selecting the multichannel analog inputsPlaying sources Using Re-EqualizationPress the Re-EQbutton on the front panel Choosing your receiver setup 06Setting up the receiverSpeaker setting Setting up the receiverSurround back speaker setting 100Hz150Hz 200Hz 6.1channel settingSubwoofer setting Crossover frequency settingSurround back speaker distance setting LFE attenuator settingFront speaker distance setting Center speaker distance settingSurround back channel input setting Dynamic range control settingDual mono setting Component video input settingsOptical digital Coaxial digital input settingsOptical digital input settings Coaxial digitalFL C FR SR SW SLSB Setting the relative volume level of each channel06Setting up the receiver Tuning directly to a station Using the tuner Listening to the radioImproving FM stereo sound 07Using the tuner Saving station presets Listening to station presets Using the tuner Naming station presetsMaking an audio or a video recording 08Making RecordingsMonitoring your recording Button Setting the remote to control other componentsSelecting preset codes directly Controlling the rest of your system09Controlling the rest of your system Setting Up Using Full Library SearchSEARCH Controlling the rest of your system Searching for preset codes using brand namesBRAND then press REMOTE SETUP Programming signals from other remote controlsClearing all the remote control settings Erasing one of the remote control button settings09Controlling the rest of your system Direct function Confirming preset codesControlling the rest of your system Function 09 Controlling the rest of your systemControls for TVs Button sComponents Controlling the rest of your systemControls for other components FunctionComponents 09Controlling the rest of your systemButton s FunctionControlling the rest of your system Preset Code ListCINERAL 09 Controlling the rest of your system1025 Controlling the rest of your systemRANK ARENA 09Controlling the rest of your systemControlling the rest of your system MD PLAYERLD PLAYER CD PLAYERDVD PLAYER TAPE DECK09Controlling the rest of your system Controlling the rest of your system AMPLIFIERMISC AUDIO RECEIVERS09Controlling the rest of your system FUNAI Controlling the rest of your system09Controlling the rest of your system SATELLITE TUNERARMSTRONG Controlling the rest of your system09Controlling the rest of your system CABLE TVAdjust the MASTER VOLUME TroubleshootingAdditional information ProblemProblem 10Additional informationRemedy FM Tuner Section Additional information SpecificationsAmplifier Section Video SectionMiscellaneous Cleaning the unit10Additional information Additional information TSWZF/02B00001 8 0 0 - 4XRB3018-A