Controlling the rest of your system
Setting the remote to control other components
There are several ways to set your remote to control the other components in your system. The easiest way to do this is to assign the component’s manufacturer preset code (listed on page 55) to one of the MULTI CONTROL buttons on the remote control.
The buttons can be set to control the following components:
Button | Controllable Components |
|
| ||
|
|
|
DVD: | DVD or LD player |
|
TV: | TV or Satellite tuner |
|
VCR: | VCR or Digital Video Recorder |
|
CD: | CD player |
|
CD Recorder, Tape deck |
| |
| or MD player |
|
TVC: | TV or Cable TV tuner |
|
TUN: | FM/AM tuner |
|
|
|
|
You can do this directly, or by searching through different preset codes until you find the right one. If you can’t find a preset code that matches the component you want to control, you can still teach the remote individual commands from another remote control (page
You can cancel or exit any of the steps by pressing and holding MUTE for three seconds.
Selecting preset codes directly
DVD | TV | VCR | |
| MULTI CONTROL |
| |
RCV | CD | TUN | TVC |
1 |
| 2 |
|
| 3 |
TESTTONE | INPUT ATT | FL DIMMER | |||
4 |
| 5 |
|
| 6 |
CH SELECT |
|
| LEVEL |
| |
7 |
| 8 |
|
| 9 |
+10 |
|
|
| EFFECT | DISPLAY |
|
| 0 |
|
| DISC |
|
|
| ENTER | ||
DTV INFO | MPX/RETURN | D.ACCESS | T.EDIT/GUIDE | ||
¶ |
| 7 |
| 3 | 8 |
BAND |
| CLASS | DTV ON/OFF | DTV MENU | |
1 |
| ¡ | 4 | ¢ | |
TOP MENU |
| AUDIO | SUBTITLE | ANGLE | |
REMOTE SETUP | STANDARD | ADV.SURR. | STEREO | ||
INPUT SEL. | SIGNAL SEL | MIDNIGHT/ | MUTE | ||
LOUDNESS |
RECEIVER CONTROL
1Press and hold REMOTE SETUP for three seconds.
The LCD display shows SETUP.
2Press the MULTI CONTROL button for the component you want to control.
3Use } and ] to select DIR SET then press REMOTE SETUP.
The LCD on the remote displays the component you want to control.
4Use the number buttons to enter the 4 digit preset code (see pages
The LCD display shows the code as you enter it. If you make a mistake press the } button to go back one digit. The display shows OK once you have entered a valid code. If it’s an invalid code or an error has occurred, ERROR shows in the display.
If you get an error message, check the preset code list and try again. If you can’t find or properly enter a preset code, you can still teach the remote individual commands from another remote control (page 49).
•If you assign a preset code for the TUNER button, you won’t be able to control the built- in tuner of this receiver using the remote.
Reset the remote to the
5Repeat steps 1 through 4 for the other components you want to control.
09
47
En