06Setting up the receiver
Dynamic range control setting
• Default setting: OFF
Dynamic range is the difference between the loudest and softest sounds in any given signal. With this setting, you can compress the dynamic range, so that low level sounds can be heard more easily (sounding relatively louder) yet louder sounds won’t be too overbearing.
•Press ’ or ‘ to set the dynamic range control (OFF, MAX, or MID).
•When the volume level is increased, set to OFF.
•When listening at low volumes, set to MAX for maximum dynamic range compression.
•Dynamic range control is effective only when a Dolby Digital signal is being played back.
Dual mono setting
• Default setting: ch1
The dual mono setting can only be used when listening to Dolby Digital discs with dual mono encoding. These discs are not widely used, but are sometimes used when it is necessary to have one language on one channel and a different language on the other. With this setting you can choose which channel in the dual mono setting you want to listen to.
You will hear the channel you have selected (either ch1 or ch2) through your center speaker. If you don’t have a center speaker, you will hear the channel you have selected through both front speakers. In the L ch 1. R ch 2 setting, the left front speaker will play channel 1 and the right front speaker will play channel 2.
•Use ’ or ‘ to cycle through the possible dual mono settings.
L ch 1.R ch 2
ch2 ch1
Component video input settings
Here you tell the receiver what components you have hooked up to the component video jacks on the back of the receiver.
Component video 1:
• Default settings: DVD
1Use ’ or ‘ to assign the component video 1 input (DVD, TV, VCR or OFF).
Component video 2:
• Default setting: TV
2Use ’ or ‘ to assign the component video 2 input (DVD, TV, VCR or OFF).
Surround back channel input setting
• Default setting: SB 2ch IN
You only have to make this setting if you are using a separate component for decoding DVDs, and the component has only one surround back channel output. If this is the case, select SB 1ch IN, otherwise leave it set to
SB 2ch IN.
•Use ’ or ‘ to select SB 2ch IN or
SB 1ch IN.
40
En