Application on single instrument | Nilfisk-ALTO ALTO Q manual

5.2Using your LTO-Q in a sound reinforcement system

You can successfully use your LTO-Q in a sound reinforcement system in order to:

Cut out undesirable frequencies such as tape hiss and/or floor rumble.

Create sounds effects enlarging the stereo image.

Eliminate feedback using very sharp Q control on selected frequencies.

Overboost or overattenuate selected frequencies thanks to the overlapping frequency range of the five bands available.

5.3Application on single instrument

If you wish to use your LTO-Q as an "in line" processor and use it for single instrument equalisation, you must connect the output of the instrument to the input of your LTO-Q and the output of the LTO-Q to the input of an amplifier.

	AC INPUT
120V-110	95-120V /210-240V 60-50Hz
	Rated Power Consumption 9W

220-240V

FUSE:

210-240V: T200mAL 250VAC

95-120V: T315mA 250VAC

REPLACE FUSE WITH CORRECT TYPE ONLY

	Apparaten skall anslutas till
	jordat uttag nar den ansluts
A101	till ett natverk

TIP / PIN 2			TIP / PIN 2
RING / PIN3			RING / PIN3
SLEEVE / PIN 1			SLEEVE / PIN 1
NEW	TIDE	NEW	TIDE
	3		3
2	1	2	1

Input

MIC level signal

Main Output

Stereo Program Source

5.4 Application on main MIX

Follow this chart and you will use the total flexibility of your LTO-Q on the Main Mix.

	AC INPUT
120V-110	95-120V /210-240V 60-50Hz
	Rated Power Consumption 9W