![](/images/new-backgrounds/1031716/3171611x1.webp)
5.The INPUT control
You can control the amount of the audio signal fed into your LTO-Q
6.The HIGH CUT control
This control, when activated will cut the high frequencies with a slope of 12dB per octave in a range of 2.5 kHz to 30 kHz. So if you set this control at the maximum position of 30 kHz, the audio signal will pass through without alteration.
7.The LOW CUT control
This control, when activated will cut the low frequencies with a slope of 12dB per octave in a range of 10 Hz to 400 Hz. So if you set this control at the minimum position of 10 Hz, the audio signal will pass through without alteration.
8.The LEVEL control
The level boost or attenuation is set with this control. The adjusting range goes from
9.The BANDWIDHT control
This control adjusts the width and can be set from a minimum of 0.03 octaves to a maximum of 1.6 octaves.
10.The FREQUENCY control
This control set the center frequency point of the filter.
11.IN/OUT switch
It activates/disactivates the correspondent band.
3.2 The Rear Panel
12
A101
AC INPUT
/210-240V
60-50Hz
FUSE:
REPLACE FUSE WITH CORRECT TYPE ONLY
Apparaten skall anslutas till jordat uttag nar den ansluts till ett natverk
TIP / PIN 2 |
|
| TIP / PIN 2 |
RING / PIN3 |
|
| RING / PIN3 |
SLEEVE / PIN 1 |
|
| SLEEVE / PIN 1 |
NEW | TIDE | NEW | TIDE |
| 3 |
| 3 |
2 | 1 | 2 | 1 |
OUTPUT | INPUT |
13 | 15 | 14 |
12.Voltage Selector and Fuse Holder
You must be sure of the Voltage available in your Country because this is a Dual Voltage Unit. Voltage operation can be changed through the fuse protecting the power supply but this operation must be performed by a qualified Engineer.
|
|
|
|
|
| ||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
THIS IS SET FOR 110V AC TO 120V AC OPERATION
THIS IS SET FOR 220V AC TO 240V AC OPERATION
Please note the triangular markers on both sides of the fuse holder (See figure above), To change the voltage pull the fuse holder out, rotate it 180 and push it back again. The operating voltage will be indicated by one of the two triangular markers.
5