McCulloch MC18542LT, 96012010400, 532 43 27-66 Tractor, Blade Care, Blade Removal See Fig, Battery

Page 15

MAINTENANCE

TRACTOR

Always observe safety rules when performing any maintenance.

BRAKE OPERATION

If tractor requires more than five (5) feet to stop at highest speed in highest gear on a level, dry concrete or paved surface, then brake must be checked and adjusted. (See “TO CHECK BRAKE” in the Service and Adjustments section of this manual).

TIRES

•Maintain proper air pressure in all tires (See the sides of tires for proper PSI).

•Keep tires free of gasoline, oil, or insect control chemicals which can harm rubber.

•Avoid stumps, stones, deep ruts, sharp objects and other hazards that may cause tire damage.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local parts dealer. Tire sealant also prevents tire dry rot and corrosion.

OPERATOR PRESENCE SYSTEM AND REVERSE OPERATION SYSTEM (ROS) (See Fig. 9)

Be sure operator presence and reverse operation systems are working properly. If your tractor does not function as described, repair the problem immediately.

•The engine should not start unless the brake pedal is fully depressed, and the attachment clutch control is in the disengaged position.

CHECK OPERATOR PRESENCE SYSTEM

•When the engine is running, any attempt by the operator to leave the seat without first setting the parking brake should shut off the engine.

•When the engine is running and the attachment clutch is engaged, any attempt by the operator to leave the seat should shut off the engine.

•The attachment clutch should never operate unless the operator is in the seat.

CHECK REVERSE OPERATION (ROS) SYSTEM

•When the engine is running with the ignition switch in the engine "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should shut off the engine.

•When the engine is running with the ignition switch in the ROS "ON" position and the attachment clutch engaged, any attempt by the operator to shift into reverse should NOT shut off the engine.

 

 

 

 

 

 

 

 

 

 

02828

ROS "ON"

ENGINE "ON" POSITION

POSITION

(NORMAL OPERATING)

 

 

 

 

 

 

Fig. 9

BLADE CARE

For best results mower blades must be kept sharp. Replace bent or damaged blades.

CAUTION: Use only a replacement blade ap- proved by the manufacturer of your tractor. Using a blade not approved by the manu- facturer of your tractor is hazardous, could damage your tractor and void your warranty.

BLADE REMOVAL (See Fig. 10)

•Raise mower to highest position to allow access to blades.

NOTE: Protect your hands with gloves and/or wrap blade with heavy cloth.

•Remove blade bolt by turning counterclockwise.

•Install new or resharpened blade with stamped "THIS SIDE UP" facing deck and mandrel assembly.

IMPORTANT: TO ENSURE PROPER ASSEMBLY, CENTER HOLE IN BLADE MUST ALIGN WITH STAR ON MANDREL ASSEMBLY.

•Install and tighten blade bolt securely (45-55 Ft. Lbs. torque).

IMPORTANT: SPECIAL BLADE BOLT HEAT TREATED.

MANDREL ASSEMBLY

 

BLADE

BLADE BOLT

STAR

(SPECIAL)

CENTER HOLE

Fig. 10

BATTERY

Your tractor has a battery charging system which is sufficient for normal use. However, periodic charging of the battery with an automotive charger will extend its life.

•Keep battery and terminals clean.

•Keep battery bolts tight.

•Keep small vent holes open.

•Recharge at 6-10 amperes for 1 hour.

NOTE:Theoriginalequipmentbatteryonyourtractorismain- tenance free. Do not attempt to open or remove caps or cov- ers. Adding or checking level of electrolyte is not necessary.

TO CLEAN BATTERY AND TERMINALS

Corrosion and dirt on the battery and terminals can cause the battery to “leak” power.

•Raise seat.

•Disconnect BLACK battery cable first then RED bat- tery cable and remove battery from tractor.

•Rinse the battery with plain water and dry.

•Clean terminals and battery cable ends with wire brush until bright.

•Coat terminals with grease or petroleum jelly.

•Reinstall battery (See “REPLACING BATTERY" in the Service and Adjustments section of this manual).

15

Page 14 Page 16
Image 15
Page 14 Page 16
Contents Operators Manual II. Slope Operation Safety RulesSafe Operation Practices for Ride-On Mowers General OperationService III. ChildrenIV. Towing Table of Contents Steering Wheel Unassembled PartsBefore Removing Tractor from Skid AssemblyTools Required for Assembly To Remove Tractor from CartonCheck Tire Pressure Check Deck LevelnessCheck for Proper Position of ALL Belts Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Towing Carts and Other Attachments Reverse Operation System ROSTo Operate on Hills To TransportTo Start Engine See Fig Before Starting the EngineCheck Engine OIL Level ADD GasolineMowing Tips General Recommendations MaintenanceBlade Removal See Fig BatteryTractor Blade CareLubrication Transaxle MaintenanceEngine BeltsMuffler CleaningClean AIR Screen AIR FilterService and Adjustments To Install Mower See FigTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Replace Motion Drive Belt See Fig Front Wheel TOE-IN/CAMBER Transaxle Gear Shift Lever Neutral Adjustment See FigTo Adjust Steering Wheel Alignment To Start Engine with a Weak Battery See FigTo Replace Headlight Bulb To Adjust Throttle Control CableTo Adjust Choke Control To Adjust CarburetorEngine OIL StorageOther Fuel SystemTroubleshooting Points Excessive Service Notes Suggested Guide for Sighting Slopes for Safe Operation Limited Warranty

532 43 27-66, MC18542LT, 96012010400 specifications

The McCulloch 96012010400, also known as the MC18542LT, is a versatile and efficient lawn tractor designed for homeowners who demand convenience and performance in their gardening tasks. This model offers a perfect blend of power, durability, and ease of use, making it an excellent choice for various lawn care activities.

One of the main features of the MC18542LT is its robust engine. Powered by a reliable and efficient Briggs & Stratton engine, it delivers sufficient horsepower to tackle even the most challenging terrain. The engine's design emphasizes fuel efficiency, allowing users to cover larger areas without frequent refueling. This is complemented by a smooth automatic transmission system that provides seamless speed adjustments and optimal control for the operator.

A standout characteristic of the McCulloch MC18542LT is its cutting deck, which measures 42 inches. This size strikes a balance between maneuverability and cutting efficiency, providing a thorough and clean cut in fewer passes. The deck height can be easily adjusted, accommodating various grass types and conditions, ensuring a well-maintained lawn throughout the mowing season.

In addition to its powerful engine and efficient cutting system, the MC18542LT is designed with user comfort in mind. The ergonomic seat and intuitive controls make the tractor easy and enjoyable to operate, allowing users to focus on their lawn care tasks without discomfort. Its compact design also allows for easy navigation in tighter spaces, making it suitable for small to medium-sized lawns.

Furthermore, the McCulloch MC18542LT incorporates advanced technologies that enhance its performance and usability. This includes features such as a turning radius that allows for sharp turns, enabling users to tackle corners and edges with precision. The tractor is also compatible with various attachments, including mulching kits, baggers, and snow blades, enhancing its versatility and making it an all-season tool for homeowners.

In conclusion, the McCulloch 96012010400, MC18542LT, or 532 43 27-66, is a well-rounded lawn tractor that meets the needs of modern gardeners. With its powerful engine, adjustable cutting deck, and user-friendly design, it offers an efficient solution for maintaining a pristine lawn. Its adaptability through various attachments further cements its position as a valuable addition to any homeowner's toolkit, ensuring that lawn care is both easy and effective.
Top Page Image Contents