McCulloch MC18542LT, 96012010400 manual Transaxle Gear Shift Lever Neutral Adjustment See Fig

Page 21

SERVICE AND ADJUSTMENTS

TRANSAXLE GEAR SHIFT LEVER NEUTRAL ADJUSTMENT (See Fig. 22)

The transaxle should be in neutral when the gear shift lever is in neutral (lock gate) position. The adjustment is preset at the factory; however, if adjustment is needed, proceed as follows:

•Make sure transaxle is in neutral.

NOTE: When the tractor rear wheels move freely, the transaxle is in neutral.

•Loosen adjustment bolt in front of the right rear wheel.

•Position the gear shift lever in the neutral position.

•Tighten adjustment bolt securely.

NOTE: If additional clearance is needed to get to adjustment bolt, move mower deck height to the lowest position.

 

NEUTRAL

GEARSHIFT LEVER

LOCK GATE

 

 

ADJUSTMENT

 

BOLT

Fig. 22

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right) when wheels are positioned straight forward, remove steer- ing wheel and reassemble per instructions in the Assembly section of this manual.

FRONT WHEEL TOE-IN/CAMBER

Your new tractor front wheel toe-in and camber is set at the factory and is normal. The front wheel toe-in and camber are not adjustable. If damage has occurred to affect the factory set front wheel toe-in or camber, contact a qualified service center.

TO REMOVE WHEEL FOR REPAIRS (See Fig. 23)

RETAINING WASHERS

RING

AXLE

COVER

SQUARE KEY (REAR

WHEEL ONLY)

Fig. 23

TO START ENGINE WITH A WEAK BATTERY (See Fig. 24)

WARNING: Lead-acid batteries gen- erate explosive gases. Keep sparks, flame and smoking materials away from batteries. Always wear eye protection when around batteries.

If your battery is too weak to start the engine, it should be recharged. (See "BATTERY" in the Maintenance section of this manual).

If “jumper cables” are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12 VOLT SYSTEM. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES.

TO ATTACH JUMPER CABLES -

•Connect one end of the RED cable to the POSITIVE

(+)terminal of each battery(A-B), taking care not to short against tractor chassis.

•Connect one end of the BLACK cable to the NEGATIVE (-) terminal (C) of fully charged battery.

•Connect the other end of the BLACK cable (D) to good chassis ground, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

•BLACK cable first from chassis and then from the fully charged battery.

•RED cable last from both batteries.

•Block up axle securely.

•Remove axle cover, retaining ring and washers to allow wheel removal (rear wheel contains a square key - Do not lose).

•Repair tire and reassemble.

•On rear wheels only: align grooves in rear wheel hub and axle. Insert square key.

•Replace washers and snap retaining ring securely in axle groove.

•Replace axle cover.

NOTE: To seal tire punctures and prevent flat tires due to slow leaks, tire sealant may be purchased from your local

WEAK OR DEAD BATTERY

FULLY CHARGED

BATTERY

parts dealer. Tire sealant also prevents tire dry rot and corrosion.

Fig. 24

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Operators Manual Safe Operation Practices for Ride-On Mowers Safety RulesGeneral Operation II. Slope OperationService III. ChildrenIV. Towing Table of Contents Steering Wheel Unassembled PartsTools Required for Assembly AssemblyTo Remove Tractor from Carton Before Removing Tractor from SkidCheck for Proper Position of ALL Belts Check Deck LevelnessCheck Brake System Check Tire PressureOperation Know Your Tractor HOW to USE Your Tractor To Operate on Hills Reverse Operation System ROSTo Transport Towing Carts and Other AttachmentsCheck Engine OIL Level Before Starting the EngineADD Gasoline To Start Engine See FigMowing Tips General Recommendations MaintenanceTractor BatteryBlade Care Blade Removal See FigEngine Transaxle MaintenanceBelts LubricationClean AIR Screen CleaningAIR Filter MufflerService and Adjustments To Install Mower See FigTo Remove Mower See Fig FRONT-TO-BACK Adjustment See Figs To Level Mower HousingTo Replace Mower Blade Drive Belt See Fig To Check BrakeTo Replace Motion Drive Belt See Fig To Adjust Steering Wheel Alignment Transaxle Gear Shift Lever Neutral Adjustment See FigTo Start Engine with a Weak Battery See Fig Front Wheel TOE-IN/CAMBERTo Adjust Choke Control To Adjust Throttle Control CableTo Adjust Carburetor To Replace Headlight BulbOther StorageFuel System Engine OILTroubleshooting Points Excessive Service Notes Suggested Guide for Sighting Slopes for Safe Operation Limited Warranty

532 43 27-66, MC18542LT, 96012010400 specifications

The McCulloch 96012010400, also known as the MC18542LT, is a versatile and efficient lawn tractor designed for homeowners who demand convenience and performance in their gardening tasks. This model offers a perfect blend of power, durability, and ease of use, making it an excellent choice for various lawn care activities.

One of the main features of the MC18542LT is its robust engine. Powered by a reliable and efficient Briggs & Stratton engine, it delivers sufficient horsepower to tackle even the most challenging terrain. The engine's design emphasizes fuel efficiency, allowing users to cover larger areas without frequent refueling. This is complemented by a smooth automatic transmission system that provides seamless speed adjustments and optimal control for the operator.

A standout characteristic of the McCulloch MC18542LT is its cutting deck, which measures 42 inches. This size strikes a balance between maneuverability and cutting efficiency, providing a thorough and clean cut in fewer passes. The deck height can be easily adjusted, accommodating various grass types and conditions, ensuring a well-maintained lawn throughout the mowing season.

In addition to its powerful engine and efficient cutting system, the MC18542LT is designed with user comfort in mind. The ergonomic seat and intuitive controls make the tractor easy and enjoyable to operate, allowing users to focus on their lawn care tasks without discomfort. Its compact design also allows for easy navigation in tighter spaces, making it suitable for small to medium-sized lawns.

Furthermore, the McCulloch MC18542LT incorporates advanced technologies that enhance its performance and usability. This includes features such as a turning radius that allows for sharp turns, enabling users to tackle corners and edges with precision. The tractor is also compatible with various attachments, including mulching kits, baggers, and snow blades, enhancing its versatility and making it an all-season tool for homeowners.

In conclusion, the McCulloch 96012010400, MC18542LT, or 532 43 27-66, is a well-rounded lawn tractor that meets the needs of modern gardeners. With its powerful engine, adjustable cutting deck, and user-friendly design, it offers an efficient solution for maintaining a pristine lawn. Its adaptability through various attachments further cements its position as a valuable addition to any homeowner's toolkit, ensuring that lawn care is both easy and effective.
Top Page Image Contents