McCulloch MC1136 manual Service and Adjustments, To Remove Mower See Fig, To Install Mower see FIG

Page 18

SERVICE AND ADJUSTMENTS

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUST- MENTS:

•Depress clutch/brake pedal fully and set parking brake.

•Place gearshift lever in neutral (N) position.

•Place attachment clutch in “DISENGAGED” position.

•Turn ignition key to “STOP” and remove key.

•Make sure the blades and all moving parts have completely stopped.

•Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.

TRACTOR

TO REMOVE MOWER (See Fig. 15)

Mower will be easier to remove from the right side of trac- tor.

•Place attachment clutch in “DISENGAGED” position.

•Move attachment lift lever forward to lower mower to its lowest position.

•Roll belt off engine pulley.

•Remove small retainer spring, and remove clutch spring off pulley bolt.

•Remove large retainer spring, slide collar off and push housing guide out of bracket.

•Disconnect anti-swaybar from chassis bracket by re- moving retainer spring.

•Disconnect suspension arms from rear deck brackets by removing retainer springs.

•Disconnect front links from deck by removing retainer springs.

•Raise lift lever to raise suspension arms. Slide mower out from under tractor.

IMPORTANT: IF AN ATTACHMENT OTHER THAN THE MOWER DECK IS TO BE MOUNTED ON THE TRACTOR, REMOVE THE FRONTLINKSANDHOOKTHECLUTCHSPRINGINTOSQUARE HOLE IN FRAME.

TO INSTALL MOWER (SEE FIG. 15)

•Raise attachment lift lever to its highest position.

•Slide mower under tractor with deflector shield to right side of tractor.

•Lower lift lever to its lowest position.

•Connect front links to mower deck and secure with retainer springs.

•Connect suspension arms to rear deck brackets and secure with retainer springs.

•Connect anti-swaybar to chassis bracket and secure with retainer spring.

SMALL RETAINER SPRING

CLUTCH SPRING

 

FLAT WASHER

SQUARE HOLE

SUSPENSION ARMS

ENGINE PULLEY

 

SMALL RETAINER SPRING

 

CLUTCH SPRING

FRONT LINK

RETAINER SPRING

RETAINER SPRINGS

(BOTH SIDES)

ANTI-SWAY BAR

BRACKET

COLLAR

HOUSING GUIDE

02694

DEFLECTOR SHIELD

LARGE RETAINER SPRING

FIG. 15

18

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Model NO. MC1136 MC1136B 11 HP 36 Inch Lawn Tractor General Operation Safety RulesSafe Operation Practices for Ride-On Mowers II. Slope OperationService III. ChildrenIV. Towing Table of Contents Unassembled Parts Steering Wheel SeatTo Remove Tractor from Carton AssemblyTools Required for Assembly Before Removing Tractor from SkidHOW to SET UP Your Tractor Install Seat See FigCheck Battery See Fig Check for Proper Position of ALL Belts Check Tire PressureCheck Deck Levelness Check Brake SystemOperation Know Your Tractor HOW to USE Your Tractor Before Starting the Engine Mowing Tips To Start Engine See FigMaintenance General RecommendationsBefore Each USE Tires TractorBrake Operation Operator Presence SystemEngine Muffler CleaningAIR Filter See Fig Spark PlugsService and Adjustments To Install Mower see FIGTo Remove Mower See Fig To Level Mower Housing FRONT-TO-BACK Adjustment See FigsTo Check and Adjust Brake See Fig To Replace Mower Blade Drive Belt See FigFront Wheel TOE-IN/CAMBER To Adjust Steering Wheel ALIGN- MentTo Replace Motion Drive Belt See Fig To Remove Wheel for Repairs See FigTo Start Engine with a Weak Battery See Fig Replacing Battery See FigsInterlocks and Relays To Remove Hood and Grill Assembly See FigTo Adjust Carburetor To Replace FuseFuel System StorageOther Engine OILTroubleshooting Points When operator leaves seat Repair Parts SchematicElectrical KEY Part NO. NO. Description Chassis and Enclosures 532 19 39-34 Dash Drive Repair Parts Steering Repair Parts Engine Optional EquipmentSeat Decals Wheels & TiresMower Lift Mower Deck KEY Part Description Policy Suggested Guide for Sighting Slopes for Safe Operation Only Ride UP and Down Hill Not Across Hill Degrees MAX
Top Page Image Contents