Sears 917.372301 manual Does not, Start, Zone/Engine control in released position

PROBLEMCAUSE

3Spark plug wire is dis- connected from the spark plug

4Bad spark plug

5Water in gasoline

CORRECTION

1 Fill gasoline tank

2 Drain gas tank and refill with fresh gasoline

3 Connect wire to spark plug

4 Replace spark plug

5 Drain tank and refill with fresh, clean gasoline

LOSS of

Power

Poor cut-

Uneven

Too much

Vibration

Starter Rope Hard to Pull

Catcher not

Filling

Completely

6Loose blade or broken blade flange

7Zone/Engine control in released position

8Zone/Engine control defective

1_ Rear of mower housing/ blade dragging in heavy grass_

2.Cutting too much grass

3.Dirty air filter

4 Build-up of grass, leaves, and trash

l r Worn or bent blade.

2 Wheel heights uneven

1, Worn or bent blade. 2 Loose blade

1 Flywheel brake is on when control bar is released

1 Cutting height too low

2. Lift on blade worn off

3 Catcher bag dirty, poor air venting

6 Tighten blade nut and/or replace blade flange

7 Depress control bar

8 Replace Zone/Englne control

1 Raise rear of mower housing one (1) setting

2Set in "Higher Cut" position

3 Replace air filter

4Disconnect spark plug wire, and clean underside of

mower housing

1 Replace blade

2Set all wheels at same height

1 Replace blade

2 Tighten blade nut

Depress control bar, before pulling on starter rope

1 Raise cutting height

2 Replace blade

3 Clean/replace catcher bag