J
¢USTO RESPONSJ LITIE
CLEAN A!R SCREEN (See Fig. 17)
Air'screen must be kept free of dirt and chaff to prevent engine damage from overheating_ Clean with a wire brush or compressed air to remove dirt and stubborn dried gum fibers°
CLEAN AIR INTAKE/COOLING AREAS
To insure proper cooling, make sure the grass screen, cooling fins, and other external surfaces of the engine are kept clean at all times.
Every 100 hours of operation (more often under extremely dusty, dirty conditions), remove the blower'housing and other cooling shrouds. Clean the cooling fins and external surfaces as necessary. Make sure the cooling shrouds are reinstalled.
NOTE: Operating the engine with a btocked grass screen, dirty or plugged cooling fins, and/or cooling shrouds re- moved will cause engine damage due to overheating°
ENGINE OIL FILTER (See Fig. 18)
Replace the engine oil filter every season or every other oil change if the tractor is used more than 100 hours in one year.
=Drain oil from engine crankcase (See "TO CHANGE ENGINE OIL" in this section of this manual, through step remove drain plug).
=Remove oil filter and wipe off filter adapter_
=Apply a thin coating of new engine oil to the rubber gasket on replacement oil filter..
oInstall replacement oil filter on filter adapter. Turn oil filter clockwise until rubber gasket contacts the _ter adapter, then tighten filter an additional 1/2 turn_
oFil! crankcase with new oil (See ''TO CHANGE EN- GINE OIL" in this section of this manual). For approxi- mate capacity see "PRODUCT SPECIFICATIONS" on page 3 of this manual.
oStart the engine and check for oi! teaks. Correct any leaks before placing engine into full operation.
OIL FILTER
i
MUFFLER
Inspect and replace corroded muffler and spark arrester (if equipped) as it could create a fire hazard and/or damage.
SPARK PLUGS
Replace spark plugs at the beginning of each mowing season or after every 100 hours of operation, whichever' occurs first. Spark plug type and gap setting are shown in "PRODUCT SPECIFICATIONS" on page 3 of this manual
IN-LINE FUEL FILTER (See Fig. 19)
The fuel filter should be replaced once each season° If fuel filter becomes clogged, obstructing fuel flow to carburetor, replacement is required.
°With engine coot, remove filter and plug fuel line sections.
°Place new fuel filter in position in fuel line with arrow pointing towards carburetor.
=Be sure there are no fuel line leaks and clamps are properly positioned.
oImmediately wipe up any spilled gasoline.
CLAMPCLAMP
FUEL FILTER
FIG. 19
CLEANING
=Clean .engine, batte_, seat, finish, etc° of all foreign matter'.
=Keep finished surfaces and wheels free of all gasoline, oil, etc_
=Protect painted surfaces with automotive type wax_
We do not recommend using a garden hose to clean your tractor unless the electrical system, muffler, air filter and carburetor are covered to keep water ouL Water in engine can result in a shortened engine _ife.
FIG. 18
18