TROUBLESHOOTaNG POINTS
PROBLEM | CAUSE. . , | . . |
CORRECTION
Wilt not start
Hard to start
1 Out of fuel
2, Engine not "CHOKED" properly,. 3, Engine flooded.,
4Bad sparkplug. 5, Dirty air filter,
6, Dirty rue! filter 7, Waterin fuet
8.Loose or damaged wiring.,
9 Carburetor out of adjustment.
t O, Engine valves out of adjustmenL
.... •r, | ' |
t.Dirty air filter. 2, Bad spark plug
3 Weak or dead battery
4.Dirty fuel filter.
5 Stale or dirty fuel
6, Loose or damaged wiring.
7..Carburetor out of adjustment.,
8, Engine valves out of adjustment..
t Fill fuel tank
2, See "TO START ENGINE" in Operation sectton_ 3, Wait several minutes before attempting to start., 4 Replace spark plug
5Clean/replace air filter, 6, Replace fuel filter,
7,, Drain fuel tank and carburetor, refill tank with fresh gasoline and replace fuel filter
8, Check all wiring,
9, Contact an authorized service center/department,
I0 Contact an authodzed service center/department
1.Cleanfreplace air fitter 2, Replace spark plug.
3, Recharge or replace battery, 4, Replace fuel filter..
5Drain fuel tank and refill with fresh gasoline_,
6Check all widng_
7,, Contact an authorized service centertdepartment
8Contact an authorized service center/department,
Engine | will not turn over | 1 | Clutch/brake pedal | not depressed., | |||
|
| 2 | Attachment | clutch | is engaged,. | ||
|
| 3, | Weak | or dead | battery. | ||
|
| 4. | Blown | fuse. |
|
| |
|
| 5, | Corroded | battery terminals, | |||
|
| 6 | Loose or damaged | wiring | |||
|
| 7, | Faulty | ignition | switch° | ||
|
| 8,. | Faulty | solenoid | or starter, | ||
|
| 9 | Fautty operator | presence switch(as), | |||
......... | r,, |
|
|
|
|
|
|
Engine | clicks but will not | 1 | Weak | or dead | battery,, | ||
start |
| 2, | Corroded | battery terminals | |||
|
| 3, | Loose | or damaged | wiring,, | ||
|
| 4 | Faulty | solenoid | or starter. | ||
Loss of power1. Cutting too much grass/too fast..
2.Throttle in "CHOKE" position.
3
5. Low oil level/dSrtyoil
6Faulty spark plug 7, Dirty fuel filter
8Stale or dirty fuel
9 Water in fuel
10..Spark plug wire loose
1 ! Dir_ engine air screen/fins.
12Dirty/clogged muffler
13Loose or damaged wiring
t4 Carburetor out of adjustment, 15, Engine valves out of adjustment
Excessive vibration | 1. | Worn, bent | or loose blade |
| 2 | Bent blade | mandrel |
| 3, | Loose/damaged part(s) | |
1 Depress clutch/brake pedal,
2.Disengage attachment clutch 3,, Recharge or replace battery, 4., Replace fuse,
5Clean battery terminals,
6Check al_ wiring,,
7, Check/replace ignition switch
8, Check/replace solenoid or starter
gContact an authorized service center/department,
IRecharge or replace battery,, 2, Clean battery terminals
3 Check all wiring,
4 Check/replace solenoid or starter.
1, Set in "Higher Cut" positiontreduce speed,.
2.Adjust throttle control,
3Clean underside of mower housing,
4CEeanlreplace air filter,
5, Cileck oil level/change oil,,
6, Ctean and regap or change spark plug, 7 Replace fuel filter,
8, Drain fue! tank and refill with fresh gasoline
9Drain fuel tank and carburetor, refill tank with fresh gasoline and replace fuel filter
10,, Connect and tighten spark plug wire,
ttClean engine air screentfins t2, Clean!replace muffler..
I3 Checkal] wiring
14 Contact an authorized service center/department
15.Contact an authorized service center/department,
1Replace blade, Tighten btade bolt.
2 Replace blade mandrel
3, Tighten loose part(s), Replace damaged parts_,
25