_ | 1 | : | ,, | ,., :::...:: .... | r_,: | ,''1 | . | ;_._, | _ | '' | ::":: | ;_;,;; | : | " |
$ERVUCE ANDADJUSTMENTS
CAUTION: BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
= | Depress clutch/brake | peda fully and set pa'rkingbrake, | ..... |
• | Place gearshift lever | in neutral (N) positron. |
|
°Place attachment clutch in "DISENGAGED" position.
oTurn ignition key "OFF" and remove key.
oMake sure the blades and all moving parts have completely stopped.
°Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plug.
TRACTOR
TO REMOVE MOWER (See Fig. 20)
Mower will be easier to remove from the right side of tractor_
o Place attachment clutch in "DISENGAGED" position.
oMove attachment lift lever forward to lower mower to its towest position,
°Roll belt off engine puliey_
°Disconnect clutch rod from clutch lever by removing retainer spring,.
. Disconnect
°Disconnect suspension arms from rear deck brackets by removing retainer springs.
=Disconnect front links from deck by removing retainer springs°
°Raise lift lever to raise suspension arms. Slide mower out from under tractor.
IMPORTANT: | IF AN ATTACHMENT OTHER THAN THE |
MOWER iS TO BE MOUNTED TO THE TRACTOR, THE R.H. AND L°H. SUSPENSION ARMS MUST BE REMOVED
FROM TRACTOR
TO INSTALL MOWER (See Fig. 20)
o Raise attachment lift lever to its highest position°
°Slide mower undertractorwith discharge guard to right side of tractor_
°Lower lift lever to its lowest position..
=Install mower in reverse order of removal instructions_.
CLUTCH | SPRING |
SUSPENSION | ENGINE |
ARMS | PULLEY |
SPRINGS (BOTH SIDES
RETAINER
SPRING
RETAINER
SPRINGS
(BOTH SIDES)
FIG. 20
19