Sears 917.25049 Ervjce AN Adjustments, Front Wheel TOE-IN Adjustment, Front Wheel Camber

Page 25

ERVJCE AN ADJUSTMENTS

FRONT WHEEL TOE-IN ADJUSTMENT

Front wheel toe-in is required for proper steering operation_ Toe-in was set at the factory and adjustment should not be necessary, If parts in the front axle or steering mechanism have been replaced or damaged, check toe-in and adjust if necessary°

TO CHECK TOE-IN (See Fig. 28)

=Position front wheels straight ahead°

=Measure distance between wheels at front and rear of tires (dimensions "A" and "B")o

•Front dimension "A" should be 1/8" to 1/4" less than rear dimension "B".

TO ADJUST TOE-IN (See Figs_ 28 and 29)

°Loosen jam nuts at adjustment sleeves on tie rod.

•Adjust tie rod until dimension "A" is1/8" to 1/4" lessthan dimension "B",

°Tighten jam nuts securely.

FIG. 28

ADJUSTMENT

SLEEVES

TIE ROD

FIG. 29

FRONT WHEEL CAMBER

The front wheel camber is not adjustable on your tractor. If damage has occurred to affect the front wheel camber,

contact your nearest authorized service center/depart- ment.

RETAINtNG

RING

AXLE

COVER

FIG. 30

REAR WHEEL -

-Block rear axle securely.,

°Remove five (5) hub bolts to allow wheel removal.

°Repair tire and reassemble° Replace and tighten hub bolts securely.

TO START ENGINE WITH A WEAK BATTERY

(See Fig. 31)

i ............CAUTION: Lead-acid batteries gener-

ateexplosivegases Keepsparks, flame and smoking materials away from bat

teries Always wear eye protection

t= when around batteries.

If your battery is too weak to start the engine, it should be recharged,, tf "jumper cables" are used for emergency starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12

VOLT NEGATIVE GROUNDED SYSTEM,. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE

GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR BATTERY TO START OTHER VEHICLES_

TO ATTACH JUMPER CABLES

=Connect each end of the RED cable to the POSITIVE

(+)terminal of each battery, taking care not to short against chassis,,

°Connect one end of the BLACK cable to the NEGA- TIVE (-) terminal of fully charged battery°

°Connect the other end of the BLACK cable to good CHASSIS GROUND, away from fuel tank and battery,

TO REMOVE CABLES, REVERSE ORDER

°BLACK cable first from chassis and then from the fully charged battePj°

RED cable last from both batteries.

TO REMOVE WHEEL FOR REPAIRS

FRONT WHEEL (See Fig,, 30) -

°Block up axle securely°

•Remove axle cover, retaining ring and washers to allow wheel removal°

•Repair tire and reassemble.

=Replace washers and snap retaining ring securefy in axle groove.

°Replace axle cover,,

"POSITIVE" (+)

"NEGATIVE" (-)

25

FIG. 31

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Model Slope Operation Safe Operation Practices for Ride-On MowersProduct Specifications Maintenance AgreementLimited TWO Year Warranty on Craftsman Riding Equipment Limited 90 DAY Warranty on BatteryFable of Contents Engine Maintenance ACCESSORME$ a Attach EntsPerformance Contents of Hardware Pack Before Rolling Tractor OFF Skid Tools Requdred for AssemblyAttach Steering Wheel See Fig To Roll Tractor OFF Skid See FigConnect Battery See Fig HOW to SET UP Your TractorInstall Seat See Fig Check Tire PressureCheck for Proper Position of ALL Belts Check Deck LevelnessChecklist Lock OPERATmONKnow Your Tractor To Adjust Mower Cutting Height See Fig HOW to USE Your TractorTo SET Parking Brake See Fig Stopping See FigTo Operate on Hills To Adjust Gauge Wheels See FigTo Operate Mower See Figs To Transport See FigsCheck Engine OIL Level See Fig Before Starting the EngineADD Gasoline To Start Engine See FigPurge Transmission Mowing TipsFreewheel lever while the engine is run Maintenance Schedule Before Each USE Lubrication ChartCusto General RecommendationsBrake Operation Tractor To Sharpen BladeTires Blade CareEngine Clean AIR Screen See FigTransaxle Cooling Transaxle Pump FluidNsibilities CustomerEngine OIL Filter Spark PlugsTo Level Mower Housing To Install MowerHeight about 3/16 Recheck measurements After adjusting To Remove Mower See FigTo Replace Mower Drive Belt Service and AdjustmentsMower Drive Belt Removal See Fig22 Both Front Links should be Equal in LengthTo Adjust Attachment Clutch To Adjust Brake See FigTo Replace Mower Blade Drive Belt See Fig To Adjust Steering Wheel Alignment To Adjust Motion Control LeverSee Fig Front Wheel TOE-IN Adjustment Ervjce AN AdjustmentsTo Start Engine with a Weak Battery Front Wheel CamberTo Remove Hood and Grill Assembly To Adjust Attachment Lift SpringTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Carburetor See Fig To Adjust Throttle Control Cable See Figs, 34Preliminary Setting Final SettingTractor BatteryOther Fuel SystemTroubleshooti Points Problem Cause CorrectionProblemcause Troubleshooting PointsClips Were Removed for Properly Secure Your WiringServicing of UNIT, They Should be Replaced toElectrical Repair Parts43 145673 Solenoid KEY Part Description471205 17/ 41 102 Chassis and Enclosures74760616 14473773680600 142992MODLNUMBIS17.2SO4so 7070E Key 1/4 x 7563R Washer Thrust Axle Harden Ground DriveCap Plunger 73800500Steering Assembly 73901000 Repair Parts\ \ Engine Tractor - Model NumberMower Deck Nut, Fig Top Lock Cntr 9/t6 KEY Part NO. noSeat Assembly Decals Tube, Front Service Item OnlyWheels & Tires 245 111212\ 2O 19 Lift AssemblyRod, Adj Lift 73350800Spring Assist Tractor -- Model Number KEY Part NO. no Description Hydro Gear Transaxle - Model Number142878 142927Hydro Gear Pump Model Number BU-10L-118 Tractor --MODEL NumberBreatherand Kohler ENGINE- Model Number MV18S, Type NumberVENT AIR Intake KEY Part Description Kohler Engine Model Number MV18S, Type NumberBaffles & Shroud KEY Part Description Breather & Vent KEY Part DescriptionP14 Not Illustrated Crankcase Carburetor KEY Part NO. no Descripon DescriptionU Ti Electric Starter KEY Part Description KEY Part NO. no CrankshaftDipstick KEY Part Description Not Illustrated -.25 450 Exhaust KEY Part+LYWHEEtI Governor KEY Part Flywheel KEY Part NO. no52 078 Fuel Pump KEY Partdescription No noOIL Filter Piston ROD OIL Switch J Camshaft and ValvesOIL PAN KEY Part LOW OIL Pressure SwitchOIL Filter KEY Part NO. no Piston & ROD KEY Part NO. noServ Notes Page Sight and Hold this Level with Only Ride UP and Down Hill Not Across HillSKY Line or Tree 15 MAXOwners Manual If YOU Need Repair Service Or Parts800473-7247 Model Number Engine Model NO. MV18S-58560

917.25049 specifications

The Sears 917.25049 is a notable lawn tractor that has garnered attention for its reliability and performance in residential lawn care. Designed primarily for homeowners who require an efficient means of maintaining their lawns, this model combines user-friendly features with robust technology to deliver an exceptional mowing experience.

At the heart of the Sears 917.25049 is its powerful engine, typically a 17.5-horsepower Briggs & Stratton overhead valve engine. This engine is known for its durability and efficiency, enabling the tractor to handle various terrains with ease. The consistent power output allows for optimal performance, making it suitable for mowing various grass types and tackling uneven landscapes.

One of the standout features of the Sears 917.25049 is its 42-inch cutting deck. This is an ideal size for residential properties, striking a balance between maneuverability and cutting efficiency. The deck design allows for side discharging, bagging, or mulching, providing users with multiple options for handling grass clippings based on their preferences and lawn care strategies.

The mower deck is equipped with adjustable cutting heights, offering several options between one and four inches. This adaptability enables homeowners to customize their mowing height based on seasonal needs, ensuring a healthy lawn throughout the year. The easy-to-use lever for adjusting the cutting height makes this process quick and convenient.

In terms of technology, the Sears 917.25049 features a hydrostatic transmission system. This technology allows for smooth acceleration and provides seamless changes in speed without the need for clutching. Users can enjoy a more intuitive driving experience, particularly when navigating tight spaces or turning corners.

The tractor also has a comfortable operator station, equipped with a spacious and well-padded seat that ensures comfort during extended mowing sessions. The steering system is designed for ease of handling, allowing for quick and responsive turning capabilities. Safety features include an operator presence control, which ensures the mower engine shuts off if the operator leaves the seat unexpectedly.

In conclusion, the Sears 917.25049 lawn tractor is an excellent choice for homeowners seeking a robust and reliable machine for lawn care. With its powerful engine, versatile cutting deck, user-friendly design, and advanced technologies, it stands out as a dependable tool for maintaining a beautiful lawn throughout the seasons.
Top Page Image Contents