Sears 917.25049 HOW to SET UP Your Tractor, Connect Battery See Fig, Install Seat See Fig

Page 8

HOW TO SET UP YOUR TRACTOR

CONNECT BATTERY (See Fig. 2)

...................... !,,! !,!

i,

I

!Will

I

IIIII

III

II II I I

nals. Before connecting battery, re-

CAUTION:metalDomovebracelets,notshort batterywristwatchtermi- bands, rings, etc.

Positive terminal must be connected first to prevent sparking from acciden- tal grounding.

•Lift hood to raised position.

°Open terminal access doors, remove terminal protec- tive caps and discard.

°If this battery is put into service after month and year indicated on label (label located between terminals) charge battery for minimum of one hour at 6-10 ampso

°First connect RED battery cable to positive (+) battery terminal with hex bolt, flat washer, lock washer and hex nut as shown° Tighten securely_

MBLY

illlllllllll iiiiill,VullllllUllli i

ii

_ULL

INSTALL SEAT (See Fig. 3)

Adjust seat before tightening adjustment knob°

iRemove cardboard packing on seat pan.

,Place seat on seat pan and assemble shoulder bolt.

°Assemble adjustment knob and flat washer loosely Do not tighten.

°Tighten shoulder bolt securely.

,Lower seat into operating position and sit on seat_

°Slide seat until a comfortable position isreached which

allows you to press clutch/brake pedal all the way down.

°Get off seat without moving its adjusted position.

°Raise seat and tighten adjustment knob securely.

SEAT

SEAT PAN

•Connect BLACK grounding cable to negative (-) bat- tery terminal with remaining hex bolt, flat washer, lock washer and hex nut. Tighten securely.

•Close terminal access doors_

Use terminal access doors for:

°Inspection for secure connections (to tighten hard-

ware),

•Inspection for'corrosion.

•Testing battery.

•Jumping (if required).

SHOULDER BOLT

ADJUSTMENT KNOB

FLAT WASHER

°Periodic charging.

DISCARD

HEX NUT

LOCK

FLAT

 

WASHER

WASHER

TERMINAL

 

 

 

PROTECTIVE

 

 

HEX

CAPS

 

 

 

 

 

TERMINAL

_'"

 

 

ACCESS

 

 

 

DOOR

.-"

 

POSITIVE

 

i

 

 

 

(RED)

 

 

 

 

 

 

CABLE

NEGATIVE

(BLACK)

CABLE

VENT HOLE (KEEP CLEAN)

FIG. 2

FIG. 3

CHECK TIRE PRESSURE

The tires on your tractor were overinflated at the factory for shipping purposes. Correct tire pressure is important for best cutting performance.

•Reduce tire pressure to PSi shown in "PRODUCT SPECIFICATIONS" on page 3 of this manual.

CHECK BRAKE SYSTEM

After you learn how to operate your tractor, check to see that the brake is properly adjusted. See "TO ADJUST BRAKE" in the Service and Adjustments section of this manual.

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Model Safe Operation Practices for Ride-On Mowers Slope OperationMaintenance Agreement Product SpecificationsLimited TWO Year Warranty on Craftsman Riding Equipment Limited 90 DAY Warranty on BatteryFable of Contents Performance ACCESSORME$ a Attach EntsEngine Maintenance Contents of Hardware Pack Tools Requdred for Assembly Before Rolling Tractor OFF SkidAttach Steering Wheel See Fig To Roll Tractor OFF Skid See FigHOW to SET UP Your Tractor Connect Battery See FigInstall Seat See Fig Check Tire PressureCheck Deck Levelness Check for Proper Position of ALL BeltsChecklist OPERATmON LockKnow Your Tractor HOW to USE Your Tractor To Adjust Mower Cutting Height See FigTo SET Parking Brake See Fig Stopping See FigTo Adjust Gauge Wheels See Fig To Operate on HillsTo Operate Mower See Figs To Transport See FigsBefore Starting the Engine Check Engine OIL Level See FigADD Gasoline To Start Engine See FigFreewheel lever while the engine is run Mowing TipsPurge Transmission Before Each USE Lubrication Chart Maintenance ScheduleCusto General RecommendationsTractor To Sharpen Blade Brake OperationTires Blade CareClean AIR Screen See Fig EngineTransaxle Cooling Transaxle Pump FluidCustomer NsibilitiesEngine OIL Filter Spark PlugsTo Install Mower To Level Mower HousingHeight about 3/16 Recheck measurements After adjusting To Remove Mower See FigService and Adjustments To Replace Mower Drive BeltMower Drive Belt Removal See Fig22 Both Front Links should be Equal in LengthTo Replace Mower Blade Drive Belt See Fig To Adjust Brake See FigTo Adjust Attachment Clutch See Fig To Adjust Motion Control LeverTo Adjust Steering Wheel Alignment Ervjce AN Adjustments Front Wheel TOE-IN AdjustmentTo Start Engine with a Weak Battery Front Wheel CamberTo Adjust Attachment Lift Spring To Remove Hood and Grill AssemblyTo Replace Headlight Bulb Interlocks and RelaysTo Adjust Throttle Control Cable See Figs, 34 To Adjust Carburetor See FigPreliminary Setting Final SettingBattery TractorOther Fuel SystemProblem Cause Correction Troubleshooti PointsTroubleshooting Points ProblemcauseProperly Secure Your Wiring Clips Were Removed forServicing of UNIT, They Should be Replaced toRepair Parts ElectricalKEY Part Description 43 145673 SolenoidChassis and Enclosures 471205 17/ 41 102144737 7476061673680600 142992MODLNUMBIS17.2SO4so Ground Drive 7070E Key 1/4 x 7563R Washer Thrust Axle HardenCap Plunger 73800500Steering Assembly Repair Parts 73901000\ \ Tractor - Model Number EngineMower Deck KEY Part NO. no Nut, Fig Top Lock Cntr 9/t6Seat Assembly Tube, Front Service Item Only DecalsWheels & Tires 245 1112Lift Assembly 12\ 2O 19Spring Assist 73350800Rod, Adj Lift Tractor -- Model Number Hydro Gear Transaxle - Model Number KEY Part NO. no Description142878 142927Tractor --MODEL Number Hydro Gear Pump Model Number BU-10L-118VENT Kohler ENGINE- Model Number MV18S, Type NumberBreatherand Kohler Engine Model Number MV18S, Type Number AIR Intake KEY Part DescriptionBaffles & Shroud KEY Part Description Breather & Vent KEY Part DescriptionP14 Crankcase Carburetor KEY Part NO. no Descripon Description Not IllustratedU Ti Crankshaft Electric Starter KEY Part Description KEY Part NO. noDipstick KEY Part Description Not Illustrated -.25 450 Exhaust KEY Part+LYWHEEtI Flywheel KEY Part NO. no Governor KEY Part52 078 Fuel Pump KEY Partdescription No noPiston ROD OIL Switch J Camshaft and Valves OIL FilterLOW OIL Pressure Switch OIL PAN KEY PartOIL Filter KEY Part NO. no Piston & ROD KEY Part NO. noServ Notes Page Only Ride UP and Down Hill Not Across Hill Sight and Hold this Level withSKY Line or Tree 15 MAXIf YOU Need Repair Service Or Parts Owners Manual800473-7247 Model Number Engine Model NO. MV18S-58560

917.25049 specifications

The Sears 917.25049 is a notable lawn tractor that has garnered attention for its reliability and performance in residential lawn care. Designed primarily for homeowners who require an efficient means of maintaining their lawns, this model combines user-friendly features with robust technology to deliver an exceptional mowing experience.

At the heart of the Sears 917.25049 is its powerful engine, typically a 17.5-horsepower Briggs & Stratton overhead valve engine. This engine is known for its durability and efficiency, enabling the tractor to handle various terrains with ease. The consistent power output allows for optimal performance, making it suitable for mowing various grass types and tackling uneven landscapes.

One of the standout features of the Sears 917.25049 is its 42-inch cutting deck. This is an ideal size for residential properties, striking a balance between maneuverability and cutting efficiency. The deck design allows for side discharging, bagging, or mulching, providing users with multiple options for handling grass clippings based on their preferences and lawn care strategies.

The mower deck is equipped with adjustable cutting heights, offering several options between one and four inches. This adaptability enables homeowners to customize their mowing height based on seasonal needs, ensuring a healthy lawn throughout the year. The easy-to-use lever for adjusting the cutting height makes this process quick and convenient.

In terms of technology, the Sears 917.25049 features a hydrostatic transmission system. This technology allows for smooth acceleration and provides seamless changes in speed without the need for clutching. Users can enjoy a more intuitive driving experience, particularly when navigating tight spaces or turning corners.

The tractor also has a comfortable operator station, equipped with a spacious and well-padded seat that ensures comfort during extended mowing sessions. The steering system is designed for ease of handling, allowing for quick and responsive turning capabilities. Safety features include an operator presence control, which ensures the mower engine shuts off if the operator leaves the seat unexpectedly.

In conclusion, the Sears 917.25049 lawn tractor is an excellent choice for homeowners seeking a robust and reliable machine for lawn care. With its powerful engine, versatile cutting deck, user-friendly design, and advanced technologies, it stands out as a dependable tool for maintaining a beautiful lawn throughout the seasons.
Top Page Image Contents