Troy-Bilt 128T manual Using the Edger Attachment, Attachments, Tilling Patterns

Page 10

Section 4: Operation

Tilling Patterns

1.When preparing a seedbed, go over the same path twice in the first row, then overlap one-half the machine width on each successive pass (Figure 10).

2.After going up and down the rows in one direction, make second passes at a right angle across the original passes (Figure 11). Again, overlap each pass to thoroughly pulverize the entire seedbed area. In very hard ground, it may take three or four passes before the desired depth is achieved.

3.If your garden is not wide enough to till lengthwise and then crosswise, then first overlap by one-half the machine width, followed by successive passes at one-quarter machine width. This overlapping method assures thorough tilling.

Figure 10: Use an overlap technique on every pass.

Figure 11: Make a second set of passes at a right angle over the first set of passes.

USING THE EDGER ATTACHMENT

The Edger Attachment makes clean, sharp edges next to walkways, driveways, paths, planted areas, patios, etc. See Assembly Steps, STEP 4: in Section 2 for instructions on attaching this attachment.

Take your time when edging. Decide how far away the edge is to be from the walk or drive, then slowly proceed using the walk or drive as your sight line.

Other attachments are can be purchased separately. See Attachments below for more details.

ATTACHMENTS

The following Tiller/Edger attachments are available where the Tiller/Edger was purchased. See your authorized dealer or contact the Factory for details.

Power Lawn Rake Attachment –

OEM-290-263 / 290-263-081

The Power Lawn Rake will help keep your lawn healthy and vigorous. Matted grass and

debris not only looks unattractive, but stifles lawn growth and overall health. This attachment mounts without tools and features dozens of tem- pered steel “fingers” that spring off the surface to pene- trate and loosen matted grass

without disturbing root growth. An 18"- wide swath covers a large lawn area quickly.

Lawn Aerator Attachment – OEM-290-264 / 290-264-081

Helps promote healthy, dense lawns by aerating and loos- ening the soil to contribute to better root growth. Four tempered steel tines punc- ture the surface of the lawn, letting nutrients

more easily reach the roots. Assembles without tools. When mounted, it takes the place of the standard tine sections.

10

Image 10
Contents Operator’s Manual Table of Contents Preparation SafetyTraining OperationNever perform maintenance when SafetyMAINTENANCE/STORAGE If fuel tank must be drained, do so outdoorsIntroduction AssemblyAssembly Steps Unpacking InstructionsAssembly Chart 1 Fuel MixtureKnow Your Equipment Features and ControlsEngine Controls Stopping Starting the Engine OperationPRE-START Preparation Starting the EngineTilling and Cultivating Adjusting Tine PatternsOperation CultivatingAttachments Using the Edger AttachmentPower Lawn Rake Attachment OEM-290-263 Tilling PatternsEquipment Maintenance MaintenanceEngine Maintenance Spark Plug Cooling System MaintenanceTine Removal Installation Arranging Tines for Narrow TillingStorage Off-Season Storage ProcedureArranging Tines For Stony Soil Conditions Troubleshooting Safety and Operating DecalsParts List Ref # DescriptionParts List Edger Attachment Page Index Y, ZMANUFACTURER’S Limited Warranty for TROY-BILT LLC, P.O. BOX 361131, CLEVELAND, Ohio 44136-0019