Section 5: Maintenance
WARNING
Before inspecting, cleaning or servicing the machine, shut off engine, wait for moving parts to stop, dis- connect spark plug wire and move wire away from spark plug.
Failure to follow these instructions can result in serious personal injury or property damage.
B |
Figure 17: Narrow tilling tine positions.
Arranging Tines
for Stony Soil Conditions
1.Prop the machine forward so it rests on the front of the tubular carrying handle. The work surface should be flat and firm.
2.Remove the hitch pin (A, Figure 16) from both sides of the unit. Remove both outer tine sections. Mark each section as a left or right side tine and whether it is an inner or outer section.
3.Remove the inner tine sections and
swap their positions (the inner
Figure 18: Stony soil tine pattern.
4.Reinstall the two outer tine sections on the sides from which they were removed (Figure 18).
5.Insert the hitch pins through the tine shafts.
To Replace Worn Tine Sections:
The tines are excessively worn if tilling takes much longer than before and the soil is not being mixed thoroughly enough.
1.Prop the machine forward so it rests on the front of the tubular carrying handle. The work surface should be flat and firm.
2.Remove the hitch pin (A, Figure 16) from both sides of the unit. Remove the old tine sections and replace them with new tine sections. Refer to Figure 16 and the tine pattern shown in the Parts List for tine pattern details. Insert the hitch pins through the tine shafts.
WARNING
•Never store your equipment when there is fuel mixture in the fuel tank.
•Never place your equipment near any source of sparks or open flame (such as from a hot water heater, a space heater or clothes dryer).
Failure to comply can result in serious personal injury or property damage.
STORAGE
IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel filter, fuel hose, or tank during storage. Also, experience indicates that alcohol- blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.
Off-Season Storage Procedure
1.Drain the fuel tank of all of the gaso-
2.Start engine and run until fuel mixture is used up. This will prevent poor perfor- mance from stale fuel when your equip- ment is taken out of storage.
NOTE: If “Gasohol” has been used, com- plete above instructions and then put 1/2 pint of gasoline properly mixed with two- cycle oil (see Fuel Mixing Chart) into fuel tank and repeat above instructions.
NOTE: Fuel stabilizer (such as
3.Let engine cool down after fuel mixture has been used up. Clean dirt and debris from engine cooling fins, linkage and other engine surfaces.
4.Pull starter handle slowly until resis-
tance is felt due to compression pressure, then stop. Release starter tension slowly to prevent engine from reversing due to compression pressure. This position will close both the intake and exhaust ports to prevent corrosion of the piston and cylinder bore.
5.Remove tines. Clean all soil and debris from dust covers and tine shaft. Lubri- cate tine shaft with light oil. Replace tines.
6.Cover engine and store equipment in a dry, sheltered location.
13