Troy-Bilt 654 manual Assembling Your Leaf Blower

SECTION 2: ASSEMBLING YOUR LEAF BLOWER

IMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil as instructed in the separate engine manual before operating your unit.

NOTE: Reference to right or left hand side of the leaf blower is observed from the operating position.

Removing Unit From Carton

•Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.

•Remove loose parts if included with unit (i.e., operator’s manual, etc.)

•Cut along corners, lay carton down flat, and remove packing material.

•Roll or slide unit out of carton and check carton thoroughly for loose parts.

	Upper Handle
	Handle Knob
Curved Head	Lower Handle
Bolt

Saddle Washer

Figure 1

Loose Parts In Carton

•Upper Handle

•Directional Discharge

•Hardware Pack

•Operator’s Manual

Hardware Pack

This leaf blower is shipped with the following loose parts in the hardware pack:

Hardware A

•Curved Head Bolts (710-1174) - Qty. 2

•Saddle Washers (736-0451) - Qty. 2

•Handle Knobs (720-0241) - Qty. 2

Hardware B

•Hex Sems Bolts (710-0259) - Qty. 2

Disconnecting Spark Plug Wire

WARNING: Before setting up your leaf blower, disconnect the spark plug wire from the spark plug and ground against the engine.

Attaching The Upper Handle (Hardware A)

•Place the upper over the lower handle, aligning the holes in the upper handle with the middle holes in the lower handle. See Figure 1.

•Secure with the curved head bolts, saddle washers, and handle knobs.

Attaching The Directional Discharge

(Hardware B)

•Slip end of directional discharge over chute opening and secure with the hex sems bolts. See Figure 2.

Hex Sems Bolt

Directional Discharge

Figure 2

5