Troy-Bilt 070, 071 warranty Setting Up Your Yard Vacuum, Opening Carton, Removing Unit From Carton

Page 6
(See Figure 1)

3

Setting Up

Your Yard

Vacuum

Upper Handle

Drive Control

Speed Control

Wing Nut

Upper Hose

Handle Bracket

Rope Guide

Cable Guide

 

Handle Knobs

Lower Hose

Handle BracketCarriage

Screws

Lower Handle

Wing Nuts

IMPORTANT: This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil as instructed in the separate engine manual before operating your machine.

NOTE: Reference to right and left hand side of the Yard Vacuum is observed from the operating position.

Opening Carton

1.Cut each corner of the carton vertically from top to bottom.

2.Remove all loose parts.

3.Remove loose packing material.

IMPORTANT

This unit is shipped without gasoline or oil in the engine. Be certain to service engine with gasoline and oil as instructed in the separate engine manual before operat- ing your machine.

NOTE: Reference to right and left hand side of the Yard Vacuum is observed from the operating position.

Bag

Safety Glasses

Hose

 

Assembly

Bottle of Engine Oil

Blower Chute

 

Operator’s Manual

 

Figure 1

Removing Unit From Carton

1.Lift unit from the rear to detach it from underlying carton material and roll unit out of carton.

2.Check carton thoroughly for any other loose parts.

NOTE: Make sure not to crimp cables while removing loose parts or the entire unit from the carton.

Loose Parts In Carton

a.Upper and Lower Handle

b.Hose Assembly

c.Safety Glasses

d.Engine Oil (May be located in bag)

e.Bag

f.Blower Chute (If Equipped)

g.Operator’s Manual

Image 6
Contents OPERATOR’S Manual 27/2006Table of Contents Finding and Recording Model NumberCustomer Support $!.%2 Your Responsibility Restrict the useSafe Operation Do not modify engine Your ResponsibilityRemoving Unit From Carton Setting Up Your Yard VacuumOpening Carton Loose Parts In CartonAttaching The Hose Assembly Attaching The HandleVacuum Attaching The BagInstalling the blower Attaching The Blower ChuteOperating Your Yard Vacuum Know Your Yard VacuumGas And Oil Fill-Up Starting EngineStopping Engine To Empty Bag Using The Nozzle VacuumOperating To Remove Blower ChuteUsing The Hose Assembly Maintaining Your Yard Vacuum Engine MaintenanceNozzle Height Adjustment LubricationDrive Control Cable Adjustment Removing The Flail ScreenDisconnect and ground the spark plug wire to retaining post Sharpening Or Replacing Chipper BladeStoring Your Yard Vacuum Problem Cause Remedy For parts and/or Accessories Please call Model 070 19 -0104 E Ring.500 Dia 20 -3035 Compression Spring To order replacement Parts, contact Or visitSaddle Washer, .320 Upper Handle Knob 710-1205 Drive ControlModels 070 12 B 21 a40 -0962 Compression Spring 41 -0778A Mounting Bracket MANUFACTURER’S Limited Warranty for U.S.A Canada