Troy-Bilt 071, 070 warranty Attaching The Blower Chute, Installing the blower

Page 9

Attaching The Blower Chute

(If Equipped)

NOTE: The bag must be removed before installing the blower chute.

8.a. Grasp blower chute with one hand and slide locking rod on mounting bracket with other hand toward engine. Use the end of mounting bracket as lever- age when sliding the locking rod. See Figure 8.

b.Slip blower chute over rim of discharge opening and release locking rod to secure chute in place.

c.Raise the nozzle height to the highest setting when using the blower chute. Refer to nozzle height adjustment in the Maintaining Your Yard Vacuum section on page 14.

NOTE: The bag/chute switch button attached to the mounting bracket must be fully depressed by the tip of front tab on the blower chute or engine will not start.

3

Setting Up

Your Yard

Vacuum

	NOTE: The bag must
	be removed before
	installing the blower
Figure 8	chute.
Figure 8

Image 9

Contents 27/2006 OPERATOR’S ManualTable of Contents Finding and Recording Model NumberCustomer Support Your Responsibility Restrict the use $!.%2Safe Operation Your Responsibility Do not modify engineOpening Carton Setting Up Your Yard VacuumRemoving Unit From Carton Loose Parts In CartonAttaching The Handle Attaching The Hose AssemblyAttaching The Bag VacuumAttaching The Blower Chute Installing the blowerKnow Your Yard Vacuum Operating Your Yard VacuumGas And Oil Fill-Up Starting EngineStopping Engine Operating Using The Nozzle VacuumTo Empty Bag To Remove Blower ChuteUsing The Hose Assembly Nozzle Height Adjustment Engine MaintenanceMaintaining Your Yard Vacuum LubricationRemoving The Flail Screen Drive Control Cable AdjustmentSharpening Or Replacing Chipper Blade Disconnect and ground the spark plug wire to retaining postStoring Your Yard Vacuum Problem Cause Remedy For parts and/or Accessories Please call Model 070 Saddle Washer, .320 Upper Handle Knob 710-1205 To order replacement Parts, contact Or visit19 -0104 E Ring.500 Dia 20 -3035 Compression Spring Drive Control12 B 21 a Models 07040 -0962 Compression Spring 41 -0778A Mounting Bracket U.S.A Canada MANUFACTURER’S Limited Warranty for