SECTION 4: OPERATING YOUR LOG SPLITTER
WARNING: Read, understand, and follow all | For best performance, the engine is designed to be |
operated at the FAST throttle position. | |
instructions and warnings on the machine and | • If weather is cold, run wedge up or down beam 6 to |
in this manual before operating. | 8 times to circulate the hydraulic fluid. |
WARNING: Wear leather work gloves, | WARNING: When starting a warm engine, |
safety shoes, ear protection, and safety | the muffler and surrounding areas are hot and |
glasses when operating log splitter. Ensure | can cause a burn. Do not touch. |
safe footing. |
|
Gas and Oil Fill-Up
•Service the engine with gasoline and oil as instructed in the engine manual packed with your log splitter. Read instructions carefully.
WARNING: Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel machine indoors or while the engine is hot or running.
NOTE: Gasoline can be added to the engine when the log splitter is in either the horizontal or vertical position. However, there are less obstructions when the unit is in the vertical position.
Before Each Use
•Remove the dipstick and check hydraulic fluid level. Refill if necessary.
•Check engine oil level. Refill if necessary.
•Fill up gasoline if necessary.
•Lubricate with engine oil the beam area where splitting wedge will slide. Do not use grease to lubricate. Make sure to lubricate both the front and the back of the beam face.
•Attach spark plug wire to the spark plug.
Starting Engine
•Attach spark plug wire to spark plug. Make certain the metal cap on the end of the spark plug wire is fastened securely over metal tip of the spark plug.
•Turn the fuel valve to the ON position.
•Move choke lever to CHOKE position.
•Slide the throttle control lever about
•Turn engine switch to ON position.
•Grasp starter handle and pull rope out slowly until engine reaches start of compression cycle (rope will pull slightly harder at this point).
•Pull rope with a rapid, full arm stroke. Keep firm grip on starter handle. Let rope rewind slowly. Repeat until engine cranks.
•After engine starts, move choke lever to OFF position. Place throttle lever to the speed desired.
Using the Log Splitter
•Place the log splitter on level, dry ground.
•Place the beam in either the horizontal or vertical position and lock in place with the appropriate locking rod.
•Block the front and back of both wheels.
•Place the log against the end plate and only split wood in the direction of the grain.
•To stabilize the log, place your hand only on sides of log. Never place hand on the end between the log and the splitting wedge.
•Only one adult should stabilize the log and operate the control handle, so the operator has full control over the log and the splitting wedge.
Control Handle
1.Move control handle FORWARD or DOWN to split wood.
2.Release the control handle to stop the wedge movement.
3.Move control handle BACK or UP to return the wedge.
Vertical Position
•Pull the horizontal beam lock out to release the beam and pivot the beam to the vertical position.
A
B
Figure 14
10