8.SYMPTOM: THE WATER PULSATES OR THERE IS MINIMUM WATER FLOW
a.This usually occurs only when the water level is low. Add water to the level shown in step 3 on page 8.
b.The filter may be dirty. Check the filter and clean it if necessary.
9.SYMPTOM: THE WATER IS NOT BEING CLEANED BY THE FILTER
a.Check to see if the filter is in place. Clean the filter if it is dirty.
b.Check the chemical balance of the water. If the pH is incorrect, the sanitizing agents will not function properly.
10.SYMPTOM: THE WATER LEVEL DROPS
a.Some water loss due to evaporation is normal. If rapid water loss occurs, or if you notice wet-
ness on the floor around the spa, the spa shell may have a leak. Contact your local spa and pool service provider for repairs.
b. A clamp or seal inside the pump compartment may be loose. Check inside the pump compart- ment for excess water, and watch the pump unit while it is operating to see if water drips from any of the plumbing. If you can identify the location of the leak inside the spa jet unit, tight- en the clamp or replace the damaged seal.
11.SYMPTOM: NO AIR FLOWS THROUGH THE ADJUSTABLE
a.The three adjustable
17