Weslo WLHS20702 user manual Setup and Assembly

Page 8

SETUP AND ASSEMBLY

Before beginning assembly, carefully read the following information and instructions:

Place all parts of the spa in a cleared area and remove the packing materials from the spa shell; do not dispose of the packing materials until assembly is completed.

Assembly requires two people.

Read each assembly step before you begin.

During assembly, make sure that all parts are turned as shown in the drawings.

TOOLS REQUIRED (not included):

• One Phillips screwdriver

1.Before beginning assembly, make sure that you have read and understand the information in the box above and on the previous page.

Remove the four screws from the access cover on the console side of the spa. Remove the access cover by sliding it down and then pulling the bottom of it away from the spa. Be careful not to damage the spa shell.

Remove the Power Cord with the GFCI (9) from inside the spa.

2.Close the valve knob on the drain hose. Tighten the two pump fittings.

Refer to step 1 above. Re-attach the access cover with the four screws.

3.Remove the warning decals (see page 5) from the spa shell. Using a damp cloth, wipe the spa shell clean. Before filling the spa, make sure that it is in the desired position and that there is room to easily service the spa. Once the spa is filled, it will have to be drained before it can be moved.

Remove the cap from the filter housing. Insert a garden hose into the filter housing as shown, and begin filling the spa. Do not use soft water. The spa may be filled with cold water; however, if warm or hot water is used, the spa will be ready for use sooner. Fill the spa until the water is at the level shown at the right. Do not overfill the spa. Replace the filter cap.

1

 

Console

 

 

 

 

 

Screws

Screws

Access

9

 

 

 

 

 

 

Cover

 

 

2

 

 

 

 

 

Pump

 

 

 

 

Fittings

 

 

 

 

Drain Hose

Valve Knob

 

3

 

 

Filter Housing

Fill to here

 

 

 

 

8

Image 8
Contents QUESTIONS? Model No. WLHS20702 Serial NoCustomer HOT Line Mon.-Fri., 6 a.m.-6 p.m. MSTTable of Contents Page Page Page Before YOU Begin If you set up the spa inside If you set up the spa outsideChoosing a Location for the SPA Do not use an extension cord with the spaSetup and Assembly Insulating Liner Plugging in the SPA Using the SPAPosting the Warning Sign Testing and Treating the Water Using the ConsoleStarting the SPA Securing the SPA CoverSPA JET Operation Maintenance Water Chemistry Draining the SPAWinter USE and Care TROUBLE-SHOOTING Symptom the Water Level Drops Symptom the Water Pulsates or There is Minimum Water FlowSymptom the Water is not Being Cleaned by the Filter Part List Model No. WLHS20702 Qty DescriptionExploded Drawing Model No. WLHS20702 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Hydrotherapy SPA Warranty