Trouble-Shooting

Most problems can be solved by following the simple steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time.

1.SYMPTOM: THE SPA WILL NOT OPERATE

a.Check to see if the GFCI breaker is tripped, or was not turned on. Reset the GFCI breaker.

b.Make sure the Heater Switch (7), located on the Control Unit (14) inside the pump compart- ment, is in the ÒONÓ position. Note: The spa will not operate if the Heater Switch is in the ÒOFFÓ position.

2.SYMPTOM: THE CIRCUIT BREAKER OR THE GFCI TRIPS WHILE THE SPA IS OPERATING

a.Reset the circuit breaker or the GFCI. If the cir- cuit breaker or the GFCI trips again, contact a qualified electrician for service.

3.SYMPTOM: THE PUMP HUMS

a.The filter may be dirty or damaged. Remove the filter housing from the spa jet unit and clean or replace the filter.

b.The pump may have a foreign object stuck in the impeller. Contact our customer service department.

c.The pump may have a loose wire connection. Contact our customer service department.

4.SYMPTOM: THE PUMP HUMS BUT DOES NOT ROTATE

a.The pump may be jammed. Contact our cus- tomer service department or, if your spa is no longer under warranty, you may also contact a local spa and pool service provider.

5.SYMPTOM: THE PUMP IS NOISY WHILE OPERATING

a.There may be debris in the pump. Contact our customer service department.

b.The pump may have a bad bearing. Contact our customer service department.

6.SYMPTOM: THE WATER DOES NOT HEAT

a.Make sure that the hydrotherapy spa is fully covered with the spa cover. The spa cover must be tight for the water to heat. Set the air control to low. Set the temperature to the desired setting. The water will heat at 1.5¡F an hour. If you are using the spa indoors, and the room temperature is maintained at 70¡F, it will take approximately 24 to 36 hours for the water to reach the set temperature.

b.If you are using the hydrotherapy spa outdoors, it may take longer for the water to heat. See the chart below for the approximate heating time.

Air Temperature	Heating Time
70¡F +	24 to 36 hours
50¡FÐ70¡F	2 to 3 days
30¡FÐ50¡F	3 to 4 days

b. If the water still has not heated after four days, contact our customer service department.

c. If actual water temperature is lower that the set temperature, and the Heat On LED indicator on the console is not lit, contact our customer ser- vice department.

7.SYMPTOM: THE WATER IS NOT BEING CLEANED BY THE FILTER

a.Check to see if the filter is in place. Clean the filter if it is dirty.

b.Check the chemical balance of the water. If the pH is incorrect, the sanitizing agents will not function properly.

8.SYMPTOM: THE WATER PULSATES OR THERE IS MINIMUM WATER FLOW

a.Adjust the water level. This usually occurs only when the water level is low. Add water until the thera-jets are covered (see step 5 on page 9).

WLHS42080 specifications

The Weslo WLHS42080 is a notable addition to the world of home fitness equipment, designed specifically for individuals who seek an effective, convenient way to exercise without the need for extensive space or high costs. This treadmill incorporates several features and technologies that make it a popular choice for fitness enthusiasts and beginners alike.

One of the key characteristics of the Weslo WLHS42080 is its compact design. With a sturdy yet lightweight frame, it easily fits into smaller areas of your home, making it ideal for apartments or rooms with limited space. The foldable design allows for easy storage when not in use, which is a significant advantage for those who want to maintain a clutter-free environment.

The treadmill is equipped with a powerful motor that delivers a smooth and consistent performance at various speeds. Typically, the Weslo WLHS42080 offers a speed range that accommodates light walking to brisk jogging, allowing users to tailor their workout according to their fitness levels and personal goals.

Another impressive feature is its built-in workout programs. These pre-set programs are designed to provide variety and challenge, enabling users to engage in different types of training sessions without the need for external coaching. This aspect not only helps keep workouts interesting but also promotes consistent progression in fitness levels.

The WLHS42080 also boasts a spacious running surface, which offers ample room for different strides and paces. This is essential for ensuring comfort during workouts, minimizing the risk of injury, and enhancing overall performance.

Additionally, the treadmill features a monitor that tracks essential workout metrics such as time, distance, speed, and calories burned. This data helps users stay motivated and allows for better tracking of fitness progress over time.

Finally, Weslo places a strong emphasis on technology and safety. The treadmill includes a safety key that ensures the machine can be stopped immediately if needed, providing peace of mind during workouts.

In summary, the Weslo WLHS42080 combines functionality, convenience, and safety, making it an excellent investment for home fitness. Its well-rounded features cater to both novice and experienced users, allowing everyone to achieve their fitness goals directly from the comfort of their home.