Weslo WLHS42080 manual Using the Hydrotherapy SPA, Plugging in the Hydrotherapy SPA

Page 10

USING THE HYDROTHERAPY SPA

The hydrotherapy spa is designed to seat two adults. The ten thera-jets can be regulated to provide a relax- ing massage to sooth away stress, and the strength of the water massage can be adjusted by the air con- trol. The hydrotherapy spa holds 200 gallons of water and offers an automatic, programmable heating (41¡F to 104¡F) and filtration system.

The guidelines below explain how to properly use the hydrotherapy spa. Follow these guidelines to maintain the hydrotherapy spa for your long-term enjoyment.

PLUGGING IN THE HYDROTHERAPY SPA

Once the hydrotherapy spa is filled with water and you have made sure that the cut-off valves to the pump are open, the power cord can be plugged in and the spa can be turned on. Note: The first time the power cord is plugged in, the spa will turn on auto- matically.

When connecting the power cord, plug the power cord directly into a grounded circuit capable of carrying 15 or more amps. No other appliance should be on the same circuit. Replace the power cord immediately if it becomes damaged.

Grounded circuit

capable of carrying

15 or more amps

GFCI

Test and Reset

Buttons

The power cord is equipped with a Ground Fault Circuit Interrupter (GFCI), located at the end of the power cord. You should always test the GFCI before using the hydrotherapy spa.

First, turn on the hydrotherapy spa by pressing the power button on the console. Once the unit is run- ning, press the GFCI ÒtestÓ button. The hydrotherapy spa should shut off. Press the ÒresetÓ button. The hydrotherapy spa should resume normal operation. If the hydrotherapy spa continues to run after the ÒtestÓ button is pressed, then the GFCI is damaged. Do not use the hydrotherapy spa until the GFCI has been repaired or replaced by a qualified electrician.

TESTING AND TREATING THE WATER

The hydrotherapy spa comes with a starter chemical pack for maintaining the water in the spa. Disregard the directions on the individual packages of ÒQUICK pHix It DOWNÓ and ÒQUICK pHix It UP.Ó However, the directions on the bottles of ÒNon-chlorine ShoxÓ and ÒBromine BaseÓ are correct. Always keep the chemi- cals away from children and pets.

The first time you use the spa, you should test and treat the water. You must also treat the water each time you refill the spa. Once you have verified that the spa is functioning properly, and the water has cir- culated for a while, remove the spa cover and add 1/3 of the ÒBromine BaseÓ bottle, and 1/3 of the ÒNon- chlorine ShoxÓ bottle to the water. Allow the water to circulate for five minutes. You should now test the pH of the water. You will need a pH test kit (not included), which can be obtained at a pool and spa supply store. The pH reading should be between 7.2 and 7.8.

If the level is too low, add half of one of the ÒQUICK pHix It UPÓ packets to the water. Let the water circu- late through the spa for five minutes. Test the pH level again. Repeat until the pH level is correct.

If the level is too high, add half of one of the ÒQUICK pHix It DOWNÓ packets to the water. Let the water cir- culate through the spa for five minutes. Test the pH level again. Repeat until the pH level is correct.

See WATER CHEMISTRY on page 16 for information concerning proper water maintenance.

STARTING THE HYDROTHERAPY SPA

Once you have tested the GFCI, you should verify the water flow from the pumping unit. Set the air control on the console to the lowest setting (see USING THE CONSOLE on page 12). The pumping unit will heat the water as it pumps. Cover the hydrotherapy spa with the spa cover. The spa cover must be tight. (See SECURING THE SPA COVER on page 13.) The water will heat at about 1.5¡F an hour with the cover on. If you are using the spa indoors, and the room temperature is maintained at 70¡F, it will take approxi- mately 24 to 26 hours for the water to reach the set temperature.

The temperature and water flow can be set or changed by the controls on the console (see USING THE CONSOLE on page 12).

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Customer HOT Line QUESTIONS?Model No. WLHS42080 Serial No Mon.ÐFri., 6 a.m.Ð6 p.m. MSTTable of Contents Limited ONE Year Massage SPA WarrantyPage Page Page Before YOU Begin Choosing a Location for the Hydrotherapy SPA If you set up the hydrotherapy spa insideIf you set up the hydrotherapy spa outside Do not use an extension cord with the hydrotherapy spaSET-UP and Assembly Be careful not to damage the spa shellPage Plugging in the Hydrotherapy SPA Using the Hydrotherapy SPATesting and Treating the Water Starting the Hydrotherapy SPASPA Shell Diagram SPA Operation Console Diagram Using the Console Using the Diverter Securing the SPA CoverPosting the Warning Sign Maintenance Water Chemistry Attaching and Removing the Access CoverSanitizing the Hydrotherapy SPA Maintaining the Proper PH BalanceDraining the Pump Opening and Closing the CUT-OFF ValvesConverting the SPA to a 240 Volt Power Source Winter USE and CareMaintenance Notes TROUBLE-SHOOTING Symptom the Water Level Drops Symptom the SPA Continues to RUN After IT has Been Shut OFFPart LISTÑModel No. WLHS42080 Key No. Qty DescriptionExploded DRAWINGÑModel No. WLHS42080 Ordering Replacement Parts

WLHS42080 specifications

The Weslo WLHS42080 is a notable addition to the world of home fitness equipment, designed specifically for individuals who seek an effective, convenient way to exercise without the need for extensive space or high costs. This treadmill incorporates several features and technologies that make it a popular choice for fitness enthusiasts and beginners alike.

One of the key characteristics of the Weslo WLHS42080 is its compact design. With a sturdy yet lightweight frame, it easily fits into smaller areas of your home, making it ideal for apartments or rooms with limited space. The foldable design allows for easy storage when not in use, which is a significant advantage for those who want to maintain a clutter-free environment.

The treadmill is equipped with a powerful motor that delivers a smooth and consistent performance at various speeds. Typically, the Weslo WLHS42080 offers a speed range that accommodates light walking to brisk jogging, allowing users to tailor their workout according to their fitness levels and personal goals.

Another impressive feature is its built-in workout programs. These pre-set programs are designed to provide variety and challenge, enabling users to engage in different types of training sessions without the need for external coaching. This aspect not only helps keep workouts interesting but also promotes consistent progression in fitness levels.

The WLHS42080 also boasts a spacious running surface, which offers ample room for different strides and paces. This is essential for ensuring comfort during workouts, minimizing the risk of injury, and enhancing overall performance.

Additionally, the treadmill features a monitor that tracks essential workout metrics such as time, distance, speed, and calories burned. This data helps users stay motivated and allows for better tracking of fitness progress over time.

Finally, Weslo places a strong emphasis on technology and safety. The treadmill includes a safety key that ensures the machine can be stopped immediately if needed, providing peace of mind during workouts.

In summary, the Weslo WLHS42080 combines functionality, convenience, and safety, making it an excellent investment for home fitness. Its well-rounded features cater to both novice and experienced users, allowing everyone to achieve their fitness goals directly from the comfort of their home.
Top Page Image Contents