Weslo WLHS42081 manual Using the Hydrotherapy SPA, Plugging in the Hydrotherapy SPA

Page 10

USING THE HYDROTHERAPY SPA

The hydrotherapy spa is designed to seat two adults. The ten thera-jets can be regulated to provide a relax- ing massage to sooth away stress, and the strength of the water massage can be adjusted by the air con- trol. The hydrotherapy spa holds 200 gallons of water and offers an automatic, programmable heating (41¡F to 104¡F) and filtration system.

The guidelines below explain how to properly use the hydrotherapy spa. Follow these guidelines to maintain the hydrotherapy spa for your long-term enjoyment.

PLUGGING IN THE HYDROTHERAPY SPA

Once the hydrotherapy spa is filled with water, and you have made sure that the cut-off valves to the pump are open, the power cord can be plugged in and the spa can be turned on. Note: The first time the power cord is plugged in, the spa will turn on auto- matically.

When connecting the power cord, plug the power cord directly into a grounded circuit capable of carrying 15 or more amps. No other appliance should be on the same circuit. Replace the power cord immediately if it becomes damaged.

Grounded circuit

capable of carrying

15 or more amps

GFCI

Test and Reset

Buttons

The power cord is equipped with a Ground Fault Circuit Interrupter (GFCI), located at the end of the power cord. You should always test the GFCI before using the hydrotherapy spa.

First, turn on the hydrotherapy spa by pressing the power button on the console. Once the unit is run- ning, press the GFCI ÒtestÓ button. The hydrotherapy spa should shut off. Press the ÒresetÓ button. The hydrotherapy spa should resume normal operation. If the hydrotherapy spa continues to run after the ÒtestÓ button is pressed, then the GFCI is damaged. Do not use the hydrotherapy spa until the GFCI has been repaired or replaced by a qualified electrician.

TESTING AND TREATING THE WATER

The hydrotherapy spa comes with a starter chemical pack for maintaining the water in the spa. Disregard the directions on the individual packages of ÒQUICK pHix It DOWNÓ and ÒQUICK pHix It UP.Ó However, the directions on the bottles of ÒNon-chlorine ShoxÓ and ÒBromine BaseÓ are correct. Always keep the chemi- cals away from children and pets.

The first time you use the spa, you should test and treat the water. You must also treat the water each time you refill the spa. Once you have verified that the spa is functioning properly, and the water has cir- culated for a while, remove the spa cover and add 1/3 of the ÒBromine BaseÓ bottle, and 1/3 of the ÒNon- chlorine ShoxÓ bottle to the water. Allow the water to circulate for five minutes. You should now test the pH of the water. You will need a pH test kit (not included) which can be obtained at a pool and spa supply store. The pH reading should be between 7.2 and 7.8.

If the level is too low, add half of one of the ÒQUICK pHix It UPÓ packets to the water. Let the water circu- late through the spa for five minutes. Test the pH level again. Repeat until the pH level is correct.

If the level is too high, add half of one of the ÒQUICK pHix It DOWNÓ packets to the water. Let the water cir- culate through the spa for five minutes. Test the pH level again. Repeat until the pH level is correct.

See WATER CHEMISTRY on page 16 for information concerning proper water maintenance.

STARTING THE HYDROTHERAPY SPA

Once you have tested the GFCI, you should verify the water flow from the pumping unit. Set the air control on the console to the lowest setting (see USING THE CONSOLE on page 12). The pumping unit will heat the water as it pumps. Cover the hydrotherapy spa with the spa cover. The spa cover must be tight. (See SECURING THE SPA COVER on page 13.) The water will heat at about 1.5¡F an hour with the cover on. If you are using the spa indoors, and the room temperature is maintained at 70¡F, it will take approxi- mately 24 to 26 hours for the water to reach the set temperature.

The temperature and water flow can be set or changed by the controls on the console (see USING THE CONSOLE on page 12).

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Customer HOT Line QUESTIONS?Model No. WLHS42081 Serial No Mon.ÐFri., 6 a.m.Ð6 p.m. MSTTable of Contents Limited ONE Year Massage SPA WarrantyPage Page Page Before YOU Begin Choosing a Location for the Hydrotherapy SPA If you set up the hydrotherapy spa insideIf you set up the hydrotherapy spa outside Do not use an extension cord with the hydrotherapy spaSET-UP and Assembly Page Plugging in the Hydrotherapy SPA Using the Hydrotherapy SPATesting and Treating the Water Starting the Hydrotherapy SPASPA Shell Diagram SPA Operation Console Diagram Using the Console Using the Diverter Securing the SPA CoverPosting the Warning Sign Maintenance Maintaining the Proper PH Balance Attaching and Removing the Access CoverWater Chemistry Draining the Hydrotherapy SPAOpening and Closing the CUT-OFF Valves Draining the PumpWinter USE and Care Removing and Cleaning the Basket Converting the SPA to a 240 Volt Power SourceChecking and Cleaning the Filter Removing and Cleaning the Filter CartridgesMaintenance Notes TROUBLE-SHOOTING Symptom the Water Level Drops Symptom the SPA Continues to RUN After IT has Been Shut OFFPart LISTÑModel No. WLHS42081 Key No. Qty DescriptionExploded DRAWINGÑModel No. WLHS42081 Ordering Replacement Parts

WLHS42081 specifications

The Weslo WLHS42081 is a notable treadmill designed for home fitness enthusiasts seeking an effective workout solution. This model combines affordability with essential features, making it ideal for beginners and those looking to maintain their fitness routine in the comfort of their own homes.

One of the standout features of the Weslo WLHS42081 is its SpaceSaver design. This innovative folding feature allows users to easily store the treadmill after use, making it a great option for those with limited space. Its lightweight construction further enhances portability, enabling users to move it around as needed.

The treadmill is equipped with a powerful 2.0 HP motor, delivering a smooth and quiet performance suited for walking and light running. Users will appreciate the reliable speed range, which offers a maximum speed of 10 miles per hour. This flexibility allows individuals to tailor their workouts according to their personal fitness levels and preferences.

In terms of training modes, the Weslo WLHS42081 features several pre-set workout programs designed to provide variety and keep users motivated. These programs are particularly beneficial for beginners who may not know where to start when designing their workouts. The console provides an easy-to-read display that shows essential metrics, including speed, time, distance, and calories burned, helping users track their progress effectively.

Additionally, this treadmill includes comfortable cushioning that reduces impact on joints, making it suitable for regular use. Its adjustable incline feature allows users to add an extra challenge to their workouts, targeting different muscle groups and enhancing cardiovascular benefits.

For those who enjoy multi-tasking during their workouts, the Weslo WLHS42081 comes with a built-in sound system compatible with most MP3 players. Users can listen to their favorite music or podcasts to stay entertained and engaged throughout their exercise sessions.

Overall, the Weslo WLHS42081 is an excellent choice for anyone looking to pursue an active lifestyle without the need for a gym membership. With its compact design, user-friendly features, and customizable workout options, it offers a practical solution for achieving fitness goals while providing a comfortable and enjoyable workout experience.
Top Page Image Contents