Woods Equipment TS52, TS44 manual Maintenance

Page 6

SAFETY RULES

ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!

(Safety Rules continued from previous page)

„Keep bystanders away from equipment.

„Never direct discharge toward people, animals, or property.

„Do not operate equipment while under the influ- ence of alcohol or drugs.

„Operate only in daylight or good artificial light.

„Keep hands, feet, hair, and clothing away from equipment while engine is running. Stay clear of all moving parts.

„Always comply with all state and local lighting and marking requirements.

„Never allow riders on power unit or attachment.

„Power unit must be equipped with ROPS or ROPS cab and seat belt. Keep seat belt securely fastened. Falling off power unit can result in death from being run over or crushed. Keep foldable ROPS systems in “locked up” position at all times.

„Always sit in power unit seat when operating controls or starting engine. Securely fasten seat belt, place transmission in neutral, engage brake, and ensure all other controls are disengaged before starting power unit engine.

„Operate tractor PTO at 540 RPM. Do not exceed.

„Do not operate PTO during transport.

„Connect PTO driveline directly to power unit PTO shaft. Never use adapter sleeves or adapter shafts. Adapters can cause driveline failures due to incorrect spline or incorrect operating length and can result in personal injury or death.

„Look down and to the rear and make sure area is clear before operating in reverse.

„Use extreme care when working close to fences, ditches, other obstructions, or on hillsides.

„Do not operate or transport on steep slopes.

„Do not stop, start, or change directions sud- denly on slopes.

„Use extreme care and reduce ground speed on slopes and rough terrain.

„Watch for hidden hazards on the terrain during operation.

„Stop power unit and equipment immediately upon striking an obstruction. Turn off engine, remove key, inspect, and repair any damage before resuming operation.

„Before performing any service or maintenance, disconnect driveline from tractor PTO.

„Before dismounting power unit or performing any service or maintenance, follow these steps: disengage power to equipment, lower the 3-point hitch and all raised components to the ground, operate valve levers to release any hydraulic pres- sure, set parking brake, stop engine, remove key, and unfasten seat belt.

„Never go underneath equipment (lowered to the ground or raised) unless it is properly blocked and secured. Never place any part of the body under- neath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak down, hydraulic system failures, mechanical failures, or movement of control levers can cause equipment to drop or rotate unexpect- edly and cause severe injury or death. Follow Oper- ator's Manual instructions for working underneath and blocking requirements or have work done by a qualified dealer.

MAINTENANCE

„Service and maintenance work not covered in OWNER SERVICE must be done by a qualified dealership. Special skills, tools, and safety proce- dures may be required. Failure to follow these instructions can result in serious injury or death.

„Before performing any service or maintenance, disconnect driveline from tractor PTO.

„Before dismounting power unit or performing any service or maintenance, follow these steps: disengage power to equipment, lower the 3-point hitch and all raised components to the ground, operate valve levers to release any hydraulic pres- sure, set parking brake, stop engine, remove key, and unfasten seat belt.

„Never go underneath equipment (lowered to the ground or raised) unless it is properly blocked and secured. Never place any part of the body under- neath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak down, hydraulic system failures, mechanical failures, or movement of control levers can cause equipment to drop or rotate unexpect- edly and cause severe injury or death. Follow Oper- ator's Manual instructions for working underneath and blocking requirements or have work done by a qualified dealer.

6Safety

TS(R) SR (3/2/2012)

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Rotary Tillers Introduction To the DealerTable of Contents LEA EL InstructivoSpecifications General InformationTraining SafetySafety Rules PreparationMaintenance Storage Safety & Instructional Decals Replace Immediately If DamagedBe Careful To Avoid Serious Injury or DeathOperation OperationDriveline Attachment Shortening DrivelineWorking Depth Adjustment Tiller Side Shift AdjustmentTractor Stability Operating ProcedureRear Shield Adjustment Clutch Run-InOperating Techniques PRE-OPERATION Check ListOwner Service Owner ServiceBlocking Method Lubrication Information Chain MaintenanceQualified Technician Maintenance Gearbox Lubrication PTO Drive LinesSlip Clutch Adjustment Driveline Shear Bolt ReplacementCleaning Blade Installation Four Blade InstallationTrouble Shooting Gearbox Maintenance Dealer ServiceDealer Service Seal ReplacementInput Shaft Repair Output Hollow Shaft RepairJoint Disassembly Universal Joint RepairJoint Assembly Install CupsAssembly Procedures AssemblyAssembly SET-UP InstructionsCrate Assembly PRE-DELIVERY Check List Dealer Check ListsDealer Check Lists Delivery Check ListRotary Tillers PartsTS44/TSR44 Rotary Tiller Assembly Hhcs TS52/TSR52 Rotary Tiller Assembly 103183652 TS60/TSR60 Rotary Tiller Assembly 102676060 Rotor Shaft 103183460 Comer Slip Clutch Drive Assembly Part QTY DescriptionComer Shear Bolt Drive Assembly Optional Gearbox Assembly Metric Series Torque Chart Bolt Torque ChartSAE Series Torque Chart AppendixBolt Size Chart AbbreviationsWarranty Rev /3/2011

TS44, TS52 specifications

Woods Equipment has long been a trusted name in the lawn and landscape industry, and their TS52 and TS44 models showcase the brand's commitment to quality and performance. These front-mounted snow throwers are designed for use with compact tractors, offering a robust solution for snow removal and ground maintenance tasks.

The TS52 is a powerful 52-inch snow thrower, while the TS44 offers a slightly more compact 44-inch option. Both models feature durable construction, ensuring they can withstand the rigors of demanding winter conditions. Made from high-strength steel, these snow throwers boast a rugged build that prioritizes longevity, making them ideal for both residential homeowners and commercial operations.

One of the standout features of the TS series is the efficient drive system. Equipped with a heavy-duty auger and impeller, these machines deliver exceptional performance in snow removal, even in deep or heavy conditions. The auger design ensures optimal snow intake, while the impeller efficiently throws snow up to 30 feet away, maximizing clearing efficiency.

Both models come with adjustable skids that allow users to customize their height settings for varying surface conditions. This versatility is essential for different applications, whether clearing driveways, sidewalks, or larger areas. The TS52 and TS44 are also equipped with electric lift capabilities, allowing for effortless attachment and detachment from the tractor.

In terms of technology, Woods has integrated features that enhance usability and control. The easy-to-use controls allow operators to adjust the chute direction effortlessly, providing precise snow placement. This is particularly valuable in busy areas where clearing snow effectively while minimizing obstruction is crucial.

The TS series snow throwers are designed with user comfort in mind. Their ergonomic controls and balanced design contribute to a more pleasant operating experience, reducing fatigue during extended use. Additionally, the machines are compatible with a variety of compact tractors, making them a flexible choice for different users.

In summary, the Woods Equipment TS52 and TS44 snow throwers represent a blend of durability, efficiency, and user-friendly design. With their robust construction, innovative technologies, and adaptable features, these snow throwers are poised to tackle winter’s challenges, ensuring users can maintain clean, safe surfaces throughout the snow season. Whether for personal use or commercial applications, the Woods TS series delivers performance that snow removal professionals and homeowners alike can rely on.
Top Page Image Contents