cal push arms (31 and 40) and attachment brackets (32) and (39).
Idler Bracket Assembly (See Figure 9 & page 16)
Remove the cap screws from the PTO bearing plate. Bolt the idler bracket assembly (36, 37, 38 and 45) to the tractor using 3/8 x
Sheave for Belt Pulley Shaft (See page 16)
Remove paint from bore of sheave (41). Put 1" splined tapered bushing in sheave (41) and insert screws to hold bushing in place, but DO NOT TIGHTEN. Slide sheave and bushing on PTO shaft and leave loose until belts are put on and lined up. After proper alignment is obtained, tighten bushing bolts evenly to 12
Mount Mower (See page 16)
Slide mower under tractor, attach crosswise rear sup- port (35) to the two channel arms (33) using 5/8 x
Channel Arms (See page 16)
Attach two channel arms (33) with single bore hole end to the mower, using 5/8 x
Attach the crosswise rear support (35) to the mower frame using one 1/2 x 2" cap screw, pivot bushing (34) and flange lock nut.
Lifting Assembly (See page 16)
Attach the lift assembly to right hydraulic arm of the tractor, using two 5/8 x
Attach two
Raise the mower on the tractor hydraulic system slightly and adjust the chain to carry the mower level. Adjust stops on lift control lever so mower will not hit tires or bottom of tractor when fully raised.
Belt Assembly & Adjustment
First put belt on bottom groove, right hand side of the center sheave. Then thread it to the left, around the left hand sheave.
Figure 3. Belt Installation
Bring the belt back across the center sheave in the center groove over to the right outside sheave.
Figure 4. Belt Installation
Then thread it back across the front of the center sheave in the top groove.
29929 (Rev. 3/28/2008) | Assembly 11 |
|
|