M1044 52" Foot Shear
SET UP
Foot Pedal
You will need the help of an assistant for this step.
To install the foot pedal as shown in Figure 5, do these steps:
1.Loosen the set screws that hold the hinge pins in place and slide them outward.
2.With the help of an assistant, position the foot pedal pivot over the hinge pin hole and insert the hinge pin.
3.Tighten the set screws to hold the hinge pin in posi- tion.
4.Link the two swivel bottoms through the side arms of the foot pedal with the supplied bolts and tighten in position.
5.When complete, the finished assembly should look like Figure 5.
Swivel Bottom |
OFF Button |
Hinge Pin |
Pedal Pivot |
Main Power |
Switch |
Set Screw |
Figure 5. Foot pedal assembly. |
Front Extension Arms
To install the front extension arms as shown in Figure 6, do these steps:
1.Loosen the 19mm bolts on the front of the table.
2.Place the front extension arms over the bolt and behind the special washers.
3.Line up the channel of the front extension arm with the channel on the table.
4.Make sure the ground surface on the front extension arm is flush with the top of the table surface.
5.Tighten the bolts and check to make sure your align- ments are still intact. If they are not, readjust.
6.When complete, the finished assembly should look like Figure 6.
Front Extension Arm Figure 6. Front extension arm installed.