Upper Rops Hoop Installation

10.Install upper roll bar hoop assembly. Secure each side of hoop with (1) ½-13NC x 3.00” long hex head bolt, (1) pin retainer washer and (1) ½-13NC center locking hex nut, into the upper mount hole of the hoop bracket. Tighten only until the nut makes contact with the hoop bracket. Do not over tighten. Hoop should pivot freely up and down. See Figure 3.

11.Install (1) EPDM washer onto each hitch pin. Position the top hoop into the up-right position and insert hitch pins. See Figure 3.

Figure 3

12.Attach (1) nylon lanyard to the handle part of each hitch pin. Insert one end of the lanyard through the retaining washer and attach to hitch pin spring clip to the eye in the lanyard. Install the spring into the hitch pin. See Figures 4, 5 and 6.

Figure 4

Figure 5

Figure 6