Yazoo/Kees ZKH61252, ZKH52252, ZKH52222 important safety instructions Maintenance

Page 14

MAINTENANCE

9.Tire pressure: Check every 25 to 50 hours. All four tires require 15 psi.

10.Battery: Check every 25 hours. Check electrolyte level. If needed fill to the full line marked on the side of the battery. Fill with distilled water. Do not try starting the engine with a weak battery. Recharge or replace the battery. The engine condensers and electronic iginition can be damaged internally with less than or more than the required 12 volts.

11.Belts: Check every 25 hours. Stop engine and remove key. Check the condition of all belts. The pump belt located under the seat and rubber engine flap. The front deck belt and

the mule drive belt.

Front caster pivots Front wheels Deck lift blocks

12. Lubrication (every 25 hours): Park brake assemblies Struts

Deck lift pivot

Pump idler pivot

Deck idler pivot

(Clean grease zerk thoroughly before greasing)

13.Fuel filter: Replace annually or as needed.

14.Hydraulic filter and oil: Change every 500 hours or yearly. Stop engine and remove key. Tilt seat forward and clean around the filter and the fittings under the hydraulic tank. Remove the filter and allow any oil to drain from the filter head. Then replace with new filter. Use only Yazoo/Kees p/n 102606, filter which has a bypass valve it and the correct micron filter. Loosen hose from fitting under hydraulic tank and allow tank to drain, reinstall hose to fitting. Fill tank with 20w - 50 motor oil to 1/4” to 1” below neck of tank and replace cap. Block up the rear of unit until wheels will rotate freely and start engine at a slow idle, move the motion control levers forward and run for several minutes. Stop engine and recheck oil level. If wheels don’t response an air lock has occured within the hydraulic system. Bleed air from lines, or let stand overnight to allow the air time to dissipate out of the oil. Retry responses & check the oil level. Note: Serious damage to the pumps and wheel motors can occur if the system is ran with an air lock. See the specification sheet for the correct kind of oil. The factory uses Quaker State Deluxe Motor Oil 20w-50.

15.Caster swivel nuts: Check at 250 hours for tightness. Remove cotter pin and tighten castle nut. Do not over tighten. Rotate nut back so a slot in the castle nut lines up with the hole in the spindle and install cotter pin.

14

Image 14
Contents Operator’s Manual for Accordance with Instructions and Common SensePage Maintenance Table of Contents SafetySetup and Adjustments Specifications Trouble ShootingOperation Safety TrainingPreparation Transportation Equipment Setup and Adjustments Mower Deck Leveling Adjustments Park BrakeCutting Height Throttle Lever Tension Adjustments Mule Drive Belt TensionReverse Spring Detent Adjustment Adjustments Adjustments Motion Control Linkage Adjustment Operating Instructions ControlsOperating Instructions Starting and Operation Maintenance Maintenance Specifications Peak TorqueProblem Possible Causes Wiring Diagram Service Record Page

ZKH61252, ZKH52222, ZKH52252 specifications

The Yazoo/Kees ZKH61252, ZKH52222, and ZKH52252 are advanced, high-performance machines designed for landscaping, grass care, and other turf management tasks. These models embody the combination of durability, efficiency, and user-friendliness that the Yazoo/Kees brand is renowned for.

One of the standout features across these models is their powerful engines, which provide reliable performance and robust torque. Powered by industry-leading engines, the ZKH series ensures that operators can tackle even the most challenging terrains with ease. The ZKH61252, with its higher horsepower, is particularly suited for large commercial properties and demanding landscaping projects, while the ZKH52222 and ZKH52252 are perfect for residential lawns and smaller tasks without sacrificing power or efficiency.

The innovative cutting deck design is another hallmark of the ZKH series. These mowers feature advanced mulching technology, which finely chops grass clippings and redistributes them evenly back onto the lawn. This not only enhances the aesthetics of the lawn but also supports healthy growth by returning nutrients to the soil. The cutting height adjustment system is precise and user-friendly, allowing operators to achieve the perfect cut for various grass types and conditions.

Ergonomics and operator comfort have not been overlooked in the ZKH series. The models feature plush, contoured seats that reduce fatigue during extended mowing sessions. The intuitive control layout ensures that operators can easily fine-tune settings without having to divert their attention from the task at hand. Additionally, the ZKH series incorporates vibration-dampening technology, which further enhances ride comfort, making it easier for operators to navigate rough terrains.

In terms of technology, the ZKH61252, ZKH52222, and ZKH52252 integrate advanced features such as zero-turn capabilities, allowing for exceptional maneuverability around obstacles, flower beds, or trees. This increases productivity and reduces mowing time, making these machines invaluable for both professional landscapers and homeowners.

Durability is also a key characteristic of the Yazoo/Kees ZKH series. With a robust frame construction and high-quality materials, these mowers are built to withstand the rigors of regular use. The maintenance-friendly design ensures that routine servicing can be accomplished quickly and easily, maximizing uptime.

In summary, the Yazoo/Kees ZKH61252, ZKH52222, and ZKH52252 represent a blend of power, efficiency, comfort, and advanced technology. Suitable for both commercial and residential applications, these machines deliver exceptional performance and a premium mowing experience, making them an excellent choice for any landscaping enthusiast.