SETUP AND ADJUSTMENTS
Control Arms
Remove top bolt in control arm and loosen bot- tom bolt, rotate the control levers to the upright position. Align the levers so they are even in the neutral position. Reinstall hardware and tighten. FIG - 1
Seat Install
1.Remove seat assembly from the crate.
2.Remove the four 5/16C nyloc nuts or 5/16C studed knobs from the bottom of the seat. Retain for use later.
3.Align the seat bottom with the holes in the seat frame. Place seat on top of the seat frame and secure with the four nuts or knobs re- moved in step 2.
4.Connect the wire harness from the seat to the frame harness.
Engine Oil
Check engine oil with dip stick. Add if needed per the engine manufactures specifications. See en- gine manual for oil type and filling specifications. FIG - 2
Loosen the discharge chute slightly and lower into position. Chute should be snug but still pivot freely.
Control | Motion |
Arm | Control |
| Lever |
FIG - 1
“F” Full
Operating Mark
Range
FIG - 2
Lift Lever
Adjustments |
|
Cutting Height |
|
Stop the mower and disengage the blades. | Deck Height |
| |
Raise the deck height lever to the transport posi- | Adjusment Plates |
tion. |
|
Remove the height adjustment pin and place it in |
|
the desired cutting height hole. Lower the lift lever |
|
down onto pin. NOTE: |
|
in the proper position for maximum deck floata- |
|
tion. See the decal on the front deck for proper |
|
settings. FIG - 3 |
|
FIG - 3
16