!
FIGURE 2.
FIGURE 3.
Screws | _- ATI'ACHINGTHE SEAT |
7 | Remove the four screws which secure the seat to the |
seat pivot bracket. Turn the seat around and place in | |
position against the seat pivot bracket, lining up the | |
| slotted holes in the pivot bracket with the holes in the |
| seat. Select desired position for the seat, and secure |
| with the four screws. See figure 2. |
NOTE: Your seat may have been shipped in a box.
Remove the four screws from the bottom of seat and
\place seat in position against the seat pivot bracket. Follow the directions above to attach the seat.
ATTACHINGTHE CHUTE DEFLECTOR
| The chute deflector must be attached to the right side | ||
H .=xNuts | of the deck so that it covers the chute opening. | ||
|
|
| |
(:upped |
|
|
|
'ashers |
| unless the chute deflector | has been |
| _hb | ||
| ARNING: Do not operate | your unit | |
properly installed.
1.Make certain deck is raised to its highest position (lift lever pulled all the way back).
NOTE: Your mowing deck may be equipped with a optional mulching plug. Remove the mulching plug by removing the wing nut on top of the deck. Grasp the mulching plug and pull out of the deck.
2.Remove the hex head cap screws, cupped washers and hex nuts which are attached to the
deck next to the chute opening.
Place the chute deflector in position as shown in figure 3. Secure with hardware just removed.
Cupped sides of washers go against the chute deflector.
. If you wish to mulch, lift up the chute and insert optional mulching plug through chute opening. Line up the bolt on mulching plug with the hole in the top of deck. Push up on the end of the mulch- ing plug and secure with the wing nut.
TIRE PRESSURE
The tires on your unit may be
any circumstances is 30 p.s.i. Equal tire
_ ARNING: Maximum tire pressure under pressure should be maintained on all
tires.