,ckHanger _-_
ustable/
L
"IGURE 4.
Positive Terminal |
| |
(Inside | Rubber Boot) |
|
il | U | Battery |
Q
<--LEVELING THE DECK
With unit on hard, level surface, measure the distance from the bottom edge of the center of the left side of deck to the ground. Measure the same distance on the center of the right side of the deck, just behind the chute area. Or, place the blades in a straight line, and measure the distance from the outside edge of the blade tips to the ground.
If adjustment is needed, proceed as follows.
1.Remove the hairpin clip and flat washer from the bottom of the adjustable lift link on the left side of the deck. (Hairpin clip and flat washer are on the inside of the lift link.)
2.Pull the adjustable lift link out of the deck hanger channel. See figure 4. Turn the adjustable lift link up or down as necessary to level the deck. Usually only one or two turns are needed.
3.Insert the end of the adjustable lift link into the hole in the deck hanger channel. Recheck the adjustment. Readjust if necessary.
4.When deck is level, secure end of adjustable lift link with flat washer and hairpin clip.
/
Negative
Cable Negative Battery
FIGURE 5. Terminal Compartment
Battery
Slot
| Reinforcement |
FIGURE 6. | Bracket |
INSTALLING THE BATTERY(TYPE "A" BATTERY)
NOTE: If battery is put into service after date shown on top of battery, charge for minimum of 1 hour at
1.Lift the seat.
2.Remove the plastic cover from the negative terminal.
3.Remove the hex bolt and nut from the negative (black) cable. Attach negative cable to the nega- tive terminal with this bolt and nut.
INSTALLING THE BATTERY(TYPE "B" BATTERY)
1.Lift the seat.
2.Make certain both the negative (black) cable and the positive (red) cable are routed up through the battery compartment as shown in figure 5.
3.Replace the battery into the battery compartment in the same position as it was before (positive ter- minal is toward the front of the unit).
4.Attach the positive (red) cable to the positive terminal of the battery. Secure with hex bolt and nut previously removed. Slide rubber boot down over the positive terminal.
5.Remove the hex bolt and nut from the negative
(black) cable. Attach negative cable to the nega- tive terminal with this bolt and nut.
6.Secure battery by hooking battery strap into slot in rear frame, under the fender. See figure 6.
7.Insert the drain tube through the hole in the trans- axle reinforcement bracket located on the right side of the unit. See figure 6. Be certain drain tube is routed away from the wheel rim.
8.Trim excess end of drain tube if necessary (about 4" should extend past the bracket or cable tie).