Yard Machines 509 manual Know Your Lawn Mower, Stopping Engine

Page 11

SECTION 5: KNOW YOUR LAWN MOWER

Read this owner’s manual and safety rules before operating your lawn mower. Compare the illustrations in Figure 14 with your lawn mower to familiarize yourself with the location of various controls and adjustments. Save this manual for future reference.

WARNING: The operation of any lawn mower can result in foreign objects being thrown into the operator’s eyes and causing severe eye damage. Always wear safety glasses while operating the mower, or while performing any adjustments or repairs on it.

Blade Control

Handle

Recoil

Starter

Cutting Height

Adjustment Lever

Discharge

Chute

Figure 14

Recoil Starter

The recoil starter is attached to the right lower handle. Stand behind the unit and pull the recoil starter to start the unit. See Figure 14.

Engine Controls

See the separate engine manual for the location and function of the controls on the engine.

Blade Control Handle

The blade control handle is located on the upper handle of the mower. The blade control handle must be depressed in order to operate the unit. Release blade control handle to stop engine and blade.

WARNING: This blade control mechanism is a safety device. Never attempt to bypass its operations.

Stopping Engine

Release blade control handle to stop the engine and the blade.

Disconnect spark plug wire and ground it to a bolt on the engine.

WARNING: Before using your lawn mower, again refer to the Safety Section in this manual. Always be careful.

Cutting Height Adjustment Lever

These levers are located on each front wheel and are used to adjust the cutting height. Both levers have to be at the same relative position to ensure uniform cut.

11

Image 11
Contents OPERATOR’S Manual Table of Contents General Operation Maintaining SafetySlope Operation Page Slope Gauge Contents of Hardware Pack Removing Unit From Carton Disconnecting Spark Plug WireSetting Up Your Lawn Mower Assembling Your Lawn MowerAttaching Starter Rope Installing Front WheelsInstalling Rear Wheels and Axle Shaft Removing Chute Retainer Installing Mulching BaffleAttaching Struts If Equipped Stopping Engine Know Your Lawn MowerStarting Engine Using Your Lawn MowerOperating Your Lawn Mower Gas and Oil Fill-UpEngine Adjustments Making AdjustmentsCutting Height Adjustment Handle Height AdjustmentLubrication Maintaining Your Lawn MowerGeneral Recommendations Deck MaintenanceEngine Storing Your Lawn Mower Problem Cause Remedy TroubleshootingModels Part Description MANUFACTURER’S Limited Warranty for