Stiga 48 E, 51 SE, PRO 48 manual Gbenglishgb, Symbols, Installation, Using the Mower

GBENGLISHGB

IMPORTANT

For the instructions relative to the engine and the battery, please read the relevant instruction handbooks.

Equipment which is marked with an asterisk (*) comes as standard in certain models or countries. Certain models do not have throttle control. The engine’s speed is set for optimal function and min- imal exhaust emissions.

HANDLE, LOWER PART

Fold back and screw tight the lower part of the handle using the screws A (fig. 2).

HANDLE, UPPER PART

Fit the upper part of the handlebar (fig. 3). The height of the handlebar above the ground can be adjusted within certain limits since the lower part is provided with slotted holes at the rear (fig. 4).

If necessary the upper part can be turned to one side to facilitate mowing close up to walls (fig. 5).

SYMBOLS

The following symbols can be found on the machine to remind you of the care and attention that are required during use.

The symbols mean:

Important: Read the instruction handbook before using the

Warning! Keep onlookers away. Beware of objects being flung out.

Warning! Keep hands and feet clear of the cutting deck when the machine is running.

Warning! Before starting any repair work, remove the spark plug cable from the spark plug.

Warning! Always tilt the lawnmower backwards when cleaning the underside. Petrol and oil can run out

if the lawnmower is tilted in the other direction.

INSTALLATION

HANDLE/BUMPER (*)

Press in the end plugs in the openings on the han- dle. Place the handle on the cover so that the holes in the handle are aligned with the holes in the cover.

Thread through the carriage bolts from underneath and secure with the locking nuts U. Press on the nut caps V (fig 1).

CABLE HOLDER

Secure the cables in the cable holders (fig. 6):

D:Start/Stop cable + Throttle cable (*)

E:Clutch cable (*) + Electric cable (*)

BATTERY (*)

The electrolyte in the battery is toxic and corrosive. It can cause serious corrosion damage etc. Avoid all contact with skin, eyes and clothing.

Before starting for the first time the battery should be charged for 24 hours, see further information under the heading MAINTENANCE, BATTERY.

Insert ignition key (*) into the ignition lock.

USING THE MOWER

STARTING THE ENGINE

1.Place the lawnmower on flat, firm ground. Do not start in long grass.

2.Make sure the spark plug cable is connected to the spark plug.

3.Set the clutch control M to (fig. 7).

4.Press in the Start/Stop loop G towards the han- dle. NOTE! The Start/Stop loop G must be kept pressed in to prevent the engine stopping (fig. 8).

5a Manual start: Grasp the starter handle and start the engine by pulling briskly on the starter cord.

5b Electric start (K*): Start the engine by turning the ignition key clockwise. Release the key as soon as the engine starts. Always make short

33