Stiga 8211-0001-70 Start, Operating tips, Stop, General safety check, Electrical safety check

Page 10

ENGLISH

4.4.1 General safety check

Object

Result

Fuel lines and con-

No leaks.

nections.

 

Electrical cables.

All insulation intact.

 

No mechanical damage.

Exhaust system.

No leaks at connections.

 

All screws tightened.

Oil lines

No leaks. No damage.

Drive the machine

The machine will stop.

forwards/back-

 

wards and release

 

the driving-service

 

brake pedal.

 

Test driving

No abnormal vibrations.

 

No abnormal sound.

4.4.2 Electrical safety check

The operation of the safety system should always be checked every time before use.

Status

Action

Result

Only HST, 4WD.

Attempt to start.

The engine

The clutch-brake

 

must not

pedal not

 

start.

depressed.

 

 

Power take-off not

 

 

activated.

 

 

Only Man. Gear

Attempt to start.

The engine

lever not in neutral.

 

must not

 

 

start.

Engine running.

The operator

The power

Power take-off

leaves the seat.

take-off

activated.

 

must disen-

 

 

gage.

Engine running.

Remove the fuse.

The engine

 

See 9:S.

must stop.

4.5Start

1.Open the fuel cock. See 10:U.

2.Check that the spark plug cable(s) is/are in- stalled on the spark plug(s).

3.Check to make sure that the power take-off is disengaged.

4a. Compact, Man: Put the gear lever in neutral.

4b. Compact HST, 4WD: Do not keep your foot on the drive pedal.

5.Starting cold engine – put the throttle control in the choke position.

Starting warm engine – put the throttle control at full throttle (approx. 2 cm behind the choke position).

6.Depress the clutch-brake pedal fully.

7. Turn the ignition key and start the engine.

8Once the engine has started, move the throttle control gradually to full throttle (approx. 2 cm behind the choke position) if the choke has been used.

9.When starting from cold, do not make the ma- chine work under load immediately, but let the engine run for a few minutes first. This will al- low the oil to warm up.

When the machine is in operation, full throttle should always be used.

4.6Operating tips

Always check that there is the correct volume of oil in the engine. This is particularly important when operating on slopes. See 4.2.

Be careful when driving on slopes. No sudden starting or stopping when driv- ing up or down a slope. Never drive across a slope. Move from the top down or from the bottom to the top.

The machine may not be driven on slopes greater than 10º in any direction.

Reduce the speed on slopes and when making sharp turns in order to retain control and reduce the risk of tipping over.

Do not turn the steering wheel to full lock when driving in top gear and at full throttle. The machine can easily topple over.

Keep hands and fingers well away from articulated steering joint and seat bracket. Risk of crushing injuries. Nev- er drive with the engine casing open.

4.7Stop

Disengage the power take-off. Apply the parking brake.

Allow the engine to idle 1-2 mins. Stop the engine by turning off the ignition key.

Shut off the petrol cock. This is particularly impor- tant if the machine is to be transported on a trailer for example.

If the machine is left unattended, re- move the spark plug cable(s) and re- move the ignition key.

The engine may be very warm immedi- ately after it is shut off. Do not touch the silencer, cylinder or cooling fins. This can cause burn injuries.

51

Image 10
Contents Stiga Park 5HST Max Page Page General DescriptionSafety system ControlsGear lever 2H Man Power take-off 2GIgnition lock 1E 10Clutch release lever HST, 4WDAreas of USE Starting and OperationStart General safety checkElectrical safety check Operating tipsMaintenance Belt transmissions Checking adjusting DrainingTransmission, oil 4WD FillingBattery Air filter, engineAir intake Patent Design Registra TionSpark plug LubricationW. s t i g a . c o m