ENGLISH
1 GENERAL
This symbol indicates WARNING. Seri- ous personal injury and/or damage to property may result if the instructions are not followed carefully.
You must read these instructions for use and the accompanying pamphlet “SAFETY INSTRUCTIONS” careful- ly, before starting up the machine.
1.1SYMBOLS
The following symbols appear on the machine. They are there to remind you of the care and atten- tion required during use and maintenance.
This is what the symbols mean: Warning!
Read the instruction manual and the safety manual before using the machine. Warning!
Watch out for discarded objects. Keep on- lookers away.
Warning!
Always wear hearing protectors.
Warning!
This machine is not designed to be driven on public roads.
Warning!
The machine, equipped with original ac- cessories, must not be driven in any direc- tion on slopes with a gradient greater than 10º.
Warning!
Risk of crushing injuries. Keep hands and feet well away from the articulated steer- ing joint.
Warning!
Risk of burn injuries. Do not touch the si- lencer/catalytic converter.
1.2 Designations
Three versions of Park Compact are available and are designated in the table below:
Machine | Designa- | |
tion | ||
| ||
|
| |
Compact with manual transmis- | Man | |
sion. | ||
| ||
Compact HST with hydrostatic | HST | |
transmission. | ||
| ||
Compact 4WD with hydrostatic | 4WD | |
transmission and four wheel | ||
drive. |
|
1.3 References
1.3.1 Figures
The figures in these instructions for use are num- bered 1, 2, 3, etc.
Components shown in the figures are marked A, B, C, etc.
A reference to component C in figure 2 is written “2:C”.
1.3.2 Headings
The headings in these instructions for use are num- bered in accordance with the following example: “1.3.1 General safety check” is a subheading to “1.3 Safety checks” and is included under this heading.
When referring to headings, only the number of the heading is normally specified. E.g. “See 1.3.1”.
2DESCRIPTION
2.1Transmission
2.1.1 Man
The machine is rear wheel drive.
The rear axle is equipped with a manual transmis- sion with 5 forward gears and one reverse gear. The rear axle is also equipped with a differential to facilitate turning.
Front mounted tools are driven by drive belts.
2.1.2 HST
The machine is rear wheel drive.
The rear axle is equipped with a hydrostatic trans- mission with infinitely variable forward and re- verse gear ratios.
The rear axle is also equipped with a differential to facilitate turning.
Front mounted tools are driven by drive belts.
2.1.3 4WD
The machine has
To make turning easier, both axles are equipped with differential.
2.2Steering
The machine is articulated. This means that the chassis is divided into a front and a rear section, which can be turned in relation to each other.
47