McIntosh MA2275 owner manual How to Connect Loudspeakers

Page 11

How to Connect Loudspeakers

How to Connect Loudspeakers

Caution: The supplied AC Power Cord should not be connected to the Rear Panel of the MA2275 Integrated Amplifier until after Connections have been made.

1.Prepare the Loudspeaker Hookup Cables that attach to the MA2275 by choosing one of the methods below:

Bare wire cable ends:

Carefully remove sufficient insulation from the cable ends, refer to figures 1, 2 & 3. If the cable is stranded, carefully twist the strands together as tightly as pos-

sible.

Note: If desired, the twisted ends can be tinned with solder to

keep the strands

together, or attach spade lug and/or banana connector.

Spade lug or prepared wire connection:

Insert the spade lug connector or prepared section of the cable end into the terminal side access hole, and tighten the terminal cap until the cable is firmly clamped into the terminal so the wires cannot slip out. Refer to figures 4, 5 & 6.

Banana plug connection:

Insert the banana plug into the hole at the top of the terminal.

Tighten the top portion of the terminal post

and the set screw to secure the banana plug

in place.

Note: The use of Banana Plugs is for use in the United States and Canada only. Refer to figures 7 and 8.

2.Connect the Loudspeaker hookup cables to the output terminals that match the impedance of the Loudspeak- er, being careful to observe the correct polarities. Out- put impedance connections of 2S (ohm), 4S (ohm) and 8S (ohm) are provided. If the Loudspeaker’s imped- ance is in-between the available connections, use the nearest lower impedance connection.

WARNING: Loudspeaker terminals are hazardous live and present a risk of electric shock. For additional instruction on making Loudspeaker Connections contact your McIntosh Dealer or McIntosh Technical Support.

Right Loudspeaker 4 ohm

Left Loudspeaker 4 ohm

11

Image 11
Contents Tube Integrated Amplifier Important Safety Instructions Please Take a Moment Customer ServiceTable of Contents Thank YouIntroduction Introduction and Performance Features Connector InformationPerformance Features Dimensions Installation of Tubes and Tube Cover Location and Ventilation Installation of Tubes, Tube Cover, Location and VentilationInstallation in a Custom Cabinet V2R Top Panel Connections and Tube LocationsJumper Plugs TAPE, DVD, Tuner Rear Panel ConnectionsHow to Connect Loudspeakers How to Connect Audio Components How to Connect for a Second Room STANDBY/ON Front Panel Controls, Displays, Push-Buttons and SwitchBass and Treble Controls How to Operate the MA2275Power On and Off Meter Mode SelectionHow to Operate the MA2275, con’t Page Remote Control Push-Buttons How to Operate by Remote Control Page Page Specifications Packing Instructions McIntosh Laboratory, Inc Chambers Street Binghamton, NY