Silvercrest SLB 450 A16 Electrical connections, Inserting batteries into the remote control

Page 11

Setting up and connecting

Electrical connections

Before you connect up, compare the connection data (voltage and frequency) on the plate of the appliance with that of your electrical network. This data must match in order to avoid damage to the appliance.

Check to ensure that the power cable of the appliance is undamaged and it will not be laid over hot surfaces and/or sharp edges.

Make sure that the power cable is not over taut or folded.

Do not let the power cable hang over edges (trip wire effect).

Inserting batteries into the remote control

NOTICE

The supplied battery (3V, type CR 2032) has already been fitted into the remote control at the factory. Before use, remove the insulation strip from the battery compartment.

To insert a new battery, proceed as follows:

‹Open the battery compartment at the rear of the remote control 9 by

rotating the circular cover in the direction of the symbol . Use a small coin for turning it.

‹Insert a battery of the type CR 2032 (3V) into the battery compartment. Make sure the polarities are correct; the positive pole faces up.

‹Close the battery compartment by replacing the round cover and turning it

in the direction of the symbol until it is firmly seated back in the housing.

Fixing the air-bubble mat into the bath

DANGER

Slippery!

If the air bubble mat is not fixed into the bathtub properly, there is a great risk of slipping!

Observe the following safety information to avoid the risks of slipping:

Carefully press the air-bubble mat onto the bottom of the bath tub until all of the suction cups on the air-bubble mat are firmly secured to the bath bottom.

Check every time before getting into the bath tub whether the air-bubble mat is still properly and firmly secured.

Do not climb into the bathtub before all the suction cups of the air-bubble mat are properly secured in the bath tub.

GB

IE

CY

SLB 450 A1

9

Image 11
Contents Spa Bath Mat CY Operating instructions Spa Bath Mat SLB 450 A1SLB 450 A1 Appendix IndexIntroduction Appliance-ComponentsIntroduction IntroductionIntroduction Risk of electrocution SafetySafety Use RestrictionsInteraction with batteries Basic Safety InstructionsAppliance must be inaccessible to people in the bathtub Appliance-Components Appliance-ComponentsItems supplied and transport inspection Setting up and connectingSetting up and connecting Safety instructionsNeeded according to the regionally established regulations Requirements on the Installation LocationDisposal of the packaging Disposal technology and are therefore recyclableFixing the air-bubble mat into the bath Inserting batteries into the remote controlElectrical connections Using aromatic oils Connecting the air hose Handling and operation Switching On and Off‹ Insert the plug into a mains power socket Handling and operationFunction selection on the pump FunctionsFunction selection with the remote control Cleaning the appliance Cleaning/TroubleshootingCleaning TroubleshootingMalfunction causes and remedies TroubleshootingDisposal of the appliance Storage/DisposalStorage/Disposal StorageAppendix Technical dataAppendix Delivery WarrantyService Importer