McIntosh Specifications of MC602 Amplifier and Performance Insights

Specifications

Specifications

Power Output	Power Requirements
Minimum sine wave continuous average power output per	100	Volts, 50/60Hz at 18 amps
channel, all channels operating is:	110 Volts, 50/60Hz at 16.5 amps
600 watts into 2 ohm load	120	Volts, 50/60Hz at 15 amps
600 watts into 4 ohm load	220	Volts, 50/60Hz at 8.2 amps
600 watts into 8 ohm load	230	Volts, 50/60Hz at 7.8 amps
	240	Volts, 50/60Hz at 7.5 amps

Rated Power Band

20Hz to 20,000Hz	Note: Refer to the rear panel of the MC602 for the correct
	voltage.

Total Harmonic Distortion

Maximum Total Harmonic Distortion at any power level from 250 milliwatts to rated power output is: 0.005% for 2, 4 or 8 ohm loads

Dynamic Headroom 2.1dB

Frequency Response

+0, -0.25dB from 20Hz to 20,000Hz +0, -3dB from 10Hz to 100,000Hz

Sensitivity

2.45Volts Balanced Input

4.9Volts Unbalanced Input

A-Weighted Signal To Noise Ratio

93dB Unbalanced (120dB below rated output) 97dB Balanced (124dB below rated output)

Intermodulation Distortion

Maximum Intermodulation Distortion if instanta- neous peak output per channel does not exceed twice the rated output, for any combination of fre- quencies from 20Hz to 20,000Hz, with all channels operating is:

0.005% for 2, 4 or 8 ohm loads

Input Impedance

10,000 ohms Balanced or Unbalanced Inputs

Wide Band Damping Factor

100 @ 8ohms

Dimensions

Front Panel: 17-3/4 inches (46cm) wide, 11 inches (28cm) high. Depth behind front mounting panel is 19-5/8 inches (49.83cm). Clearance required in front of the Front Panel is 1-3/4 inches (4.5cm) for handles.

Weight

155 pounds (70.31kg) net, 180 pounds (81.65kg) in ship- ping carton

18