How to Connect the MC602, Banana plug connection

How to Connect the MC602

Banana plug connection:

Caution: The supplied AC Power Cord should not be

connected to the Rear Panel of the MC602

Insert the banana plug into the hole at the top of the

Amplifier until after the Loudspeaker Connections

terminal. Tighten the top portion of the terminal post

have been made and the supplied protective

and the set screw to secure the banana plug in place.

Terminal Connections Cover has been installed.

Note: The use of Banana Plugs is for use in the United

Failure to observe this could result in Electric

States and Canada only.

Shock.

4. Connect the loudspeaker hookup cables to the output

1. For Remote Power Control, connect a power control

terminals that match the impedance of your loudspeak-

cable from the Control Center or Preamplifier Power

ers, being careful to observe the correct polarities. Out-

Control Out to the MC602 Power Control In.

put impedance connections of 2 ohms, 4 ohms and 8

2. Connect cables from the Balanced Outputs of a McIn-

ohms are provided. If the impedance of your loud-

tosh Preamplifier or Control Center to the MC602 Bal-

speakers is in-between the available connections, use

anced Inputs.

the nearest lower impedance connection.

Note: An optional hookup is to use unbalanced cables.

WARNING: Loudspeaker terminals are hazardous live

3. Prepare the Loudspeaker Hookup Cables that attach to

and present a risk of electric shock. For

the MC602 Power Amplifier by choosing one of the

additional instruction on making

methods below:

Loudspeaker Connections contact your

Bare wire cable ends:

McIntosh Dealer or McIntosh Technical

Carefully remove sufficient insulation from the cable

Support.

ends, refer to figures 1,

5. Attach the supplied Terminal Connections Cover with

2 & 3. If the cable is

the four Philip Head Mounting Screws (10-32 x 1/2

stranded, carefully twist

inch) to the Rear Panel of the MC602 Amplifier. Refer

the strands together as

to figure 7.

tightly as possible.

Note: There are six openings on the bottom edge of the

Note: If desired, the twisted ends can be tinned with

cover to allow for the Loudspeaker’s Cable to exit

solder to keep the strands together, or attach spade

the MC602. The Rear Chassis Handle (“U”

lug and/or banana connector.

shaped) has tapped screw openings on both sides

Spade lug or prepared wire connection:

for securing the cover to the MC602.

Insert the spade lug

6. Connect the MC602 power cord to an active AC outlet.

connector or pre-

pared section of the

cable end into the

terminal side access

hole, and tighten the termi-

nal cap until the cable is

firmly clamped into the ter-

minal so the wires cannot

Terminal

slip out. Refer to figures 4, 5

Connections

& 6.

Cover

Rear

Chassis

Handle

Cover

Mounting

Screw

Locations

Cable Openings

Figure 7