MC602 Rear Panel Connections and Switch
BALANCED INPUTS for audio cables from a preamplifier or control center audio outputs
UNBALANCED INPUTS for audio cables from a preamplifier or control cen- ter audio output
CIRCUIT BREAKER Press to reset if the am- plifier will not power up
RIGHT OUTPUT Connections for 8 ohm loudspeakers
RIGHT OUTPUT Connections for 4 ohm loudspeakers
RIGHT OUTPUT Connections for 2 ohm loudspeakers
POWER CONTROL IN receives turn on/off signals from a McIntosh component and the POWER CONTROL OUT sends a turn On/ Off signal to the next McIntosh component
INPUT MODE switch selects balanced or unbalanced 
inputs
Connect the MC602 power cord to a live AC outlet. Refer to information on the back panel to deter- mine the correct voltage
LEFT OUTPUT Connections for 8 ohm loudspeakers
LEFT OUTPUT Connections for 4 ohm loudspeakers
LEFT OUTPUT Connections for 2 ohm loudspeakers
Caution: The Loudspeaker 
Negative Connections are above chassis ground and are not common between channels. Do not combine any connections together or ground them.
7