Shindaiwa X7501970601 manual Assembling the EB854RT, Install throttle cable holder just for

Assembly

Assembling the EB854RT

IMPORTANT!

This unit is equipped with a static discharge reduction wire. This wire helps direct static buildup into the air stream reducing the felt amount to the operator.

1.	Place the blower upright on the
	ground or a sturdy work surface and
	note parts orientation as shown in
	Figure 7.
2.	Remove static wire from package
	and fix eyelet to right hand engine
	cover screw. See Figure 8.
3.	Turn the discharge tube out to a
	right angle and slip anti-static wire
	through the 102mm clamp and flex-
	ible tube.
4.	Install throttle cable holder just for-

				Throttle
				Assembly
				Swivel
				Tube
			Flexible Tube	Optional
		Throttle Cable		Long Nozzle
				(ø74 mm)
		Holder
	90° Discharge
	Tube			Straight Tube
	Anti-Static
	Wire
Figure 7	102mm Clamp	89mm Clamp	Swivel Tube	Standard Nozzle
				(ø65 mm)

ward of the 102 mm clamp, pinching

loops together to fit over end of flex-

ible tube. See Figures 10A and 10B.

5. Slip the flexible tube over the end of

the 90° discharge tube, and secure

with the 102 mm clamp.

6. Slide the throttle assembly over the

swivel tube. Do not tighten clamp at

this time.

NOTE:

Check to make sure that the 90° dis- charge tube swivels freely. If any binding is present, loosen 102 mm clamp and pull wire towards engine to get more slack and recheck for free movement.

7.Insert the static wire through the swivel tube, then install and tighten the 89mm clamp over the rotating band on the swivel tube.

8.Fold the end of the static wire back over the connection of the swivel tube. See Figure 8.

9.Grasp the straight tube, and push the straight tube over the swivel tube locking pins securing the static wire. See Figure 9.

10.Lock the straight tube to the swivel tube by rotating the straight tube noting the alignment marks. See Figure 9.

11.Grasp the nozzle, and push the nozzle over the straight tube locking pins. See Figure 9.

12.Lock the nozzle to the straight tube

Throttle
Assembly
	Fold Wire
Swivel
Tube
Throttle	Flexible Tube
Cable Holder
Static Wire
Static Wire
Connector
Figure 8
Loops

Figure 10A

Throttle

Cable

Holder

Figure 10B

Align the lock pins with the

lock slots, and push the

tubes together.

Lock Pin

Lock Slot

Rotate clockwise to lock

making sure the 3 lines are

aligned on both tubes.

Figure 9

IMPORTANT!

Blower tube installation affects blower performance! Make sure the tubes and nozzle are correctly assembled per above, and that all connections are tight. Blower tubes may come apart dur- ing use unless tubes are aligned and locked into place.

WARNING!

Danger from rotating impeller!

Stop the engine before installing or removing the blower tubes! Never perform any maintenance or assem- bly procedures on this unit while the engine is running!

by rotating the nozzle noting the alignment marks. See Figure 9.

8

13.Adjust throttle assembly for best
	The blower should now be ready
operator comfort, and tighten two
	for use.
socket-head screws securely.