Safety
This machine operates at very high speeds and has the potential to do serious damage if misused, abused or mishandled. To reduce the risk of injury, you must maintain control at all times, and observe all safety precautions during operation. Never permit a person without training or instruction to operate this machine!
NOTE:
For specific maintenance and safety infor- mation about your T230/231, AH230/231, or PB230, consult the owner's manual provided with it. If it has been lost or misplaced, contact a Shindaiwa dealer for a replacement.
WARNING!
THE PRUNER IS NOT INSULATED AGAINST ELECTRICAL SHOCK! Approaching or contacting electrical line with the pruner could cause death or serious injury. Keep the pruner at least 33 feet (10 meters) away from electrical lines or branch- es that contact electrical lines.
CAUTION!
Always maintain the Pole Pruner Tool according to this owner’s manual and follow the recommended scheduled maintenance.
Never modify or disable any of the pruner’s safety devices.
Always use genuine Shindaiwa parts and accessories when repairing or maintaining this machine.
Do not make unauthorized modifications to the pole pruner.
When transporting the pole pruner in a vehicle, tie it down securely to prevent fuel spillage or damage to the machine.
Always clear your work area of trash or hidden debris to help ensure good footing.
Keep the chain sharp and properly adjusted.
Keep the pole pruner as clean as possible. Keep it free of loose vegetation, mud, debris, etc.
Operating Precautions
WARNING!
This Shindaiwa pole pruner attachment is specifically de- signed for use on the Shindaiwa T230/231 grass trimmers, AH230/231 articulating hedge trimmers, or PB230 power broom. Installation and/or use on any other model, brand or type of power tool is not approved by Shindaiwa. Attempts to use on
Make sure the chain and sprocket are correctly adjusted before operating the pruner (see assem- bly for adjustment procedures).
Never attempt chain adjustment with the engine running!
Always make sure the cutting at- tachment is properly installed and firmly tightened before operation.
Never use a cracked or warped guide bar: replace it with a service- able one and make sure it fits properly.
If a saw blade should bind fast in a cut, shut off the engine immedi- ately. Push the branch or tree to ease the bind and free the blade.
Before starting the engine, make sure the saw chain is not contact- ing anything.
When cutting a limb that is under tension, be alert for springback so that you will not be struck by the moving limb.
Always run at wide open throttle (WOT) before contacting material to be cut.
Always stop the engine imme- diately and check for damage if you strike a foreign object or if the machine becomes tangled. Do not operate with broken or damaged equipment.
Stop the machine immediately if it suddenly begins to vibrate or shake. Inspect for broken, miss- ing or improperly installed parts or attachments.
Never transport the pruner or set it down with the engine running. An engine that’s running could be accidently accelerated causing the chain to rotate.
Make sure the scabbard is in place when transporting the pruner.
When carrying by hand, the chain should be pointing backward.
ALWAYS keep a Solid Stance. Maintain footing and balance at all times. Do not stand on slippery, uneven or unstable surfaces. Do not work in odd positions or on ladders. Do not over reach.
3