Adjusting the Chain
WARNING!
Never attempt to install, replace, or adjust the chain with the engine running.
WARNING!
The saw chain is very sharp. Wear gloves to protect your hands when handling.
CAUTION!
A loose chain can jump off the guide bar causing damage to the chain and associated equipment. Always make sure the chain is properly adjusted; check more often when you are breaking in a new chain.
IMPORTANT!
Proper chain adjustment is essential for maximum performance, long chain life, and operator safety. Always inspect chain tension before operating the pole pruner tool.
1.Place the pole pruner on a clean, flat surface. (For readjustment during operation, shut down the engine, then allow the guide bar and chain to cool before proceeding with the adjustment procedure).
2.Loosen the sprocket cover nut (A) with the plug wrench.
3.Lift the nose of the guide bar while turning the chain tensioning screw (B).
•clockwise to tighten the chain
•counter clockwise to loosen the chain.
4.Pull the chain by hand along the top of the guide bar several times from the engine to the bar’s tip. The chain should feel snug but still pull freely.
5.Tighten the sprocket cover nut securely while lifting the tip of the guide bar.
6.Inspect the chain for the correct adjustment (more frequently with a new chain). The chain should feel snug but still pull freely.
Filling the Chain Oiler Reservoir
WARNING!
Never fill the oil reservoir or adjust the oiler with the engine running.
IMPORTANT!
To prevent plastic deterioration, do not use synthetic or silicone based oil.
1.Place the pole pruner tool on a clean, flat surface with the oil filler cap (C) facing up. Wipe off any debris from the oil cap and from around the oil filler neck.
2.Remove the oil filler cap (C)and fill the reservoir with bar and chain oil, then replace the cap.
3.Wipe up any spilled oil from the unit before restarting the pole pruner.
Adjusting Oil Flow Rate
NOTE:
The automatic oiler is preset to deliver a sufficient oil discharge volume during normal operating conditions. During heavy or dry cutting conditions, the oil discharge volume may be increased to assure adequate lubrication. If oil is leaking from the bar cover
area, reduce the oil discharge volume. Refill the oil reservoir with each tank of fuel.
A
B
C
D
E
12