Shindaiwa X7502825800, LE254 manual Long Term Storage

Page 18

Long Term Storage

Whenever the unit will not be used for 30 days or longer, use the following proce- dures to prepare it for storage:

Clean external parts thoroughly.

Drain all the fuel from the fuel tank.

IMPORTANT!

Stored fuel ages. Do not mix more fuel than you expect to use in thirty (30) days, ninety (90) days when a fuel stabilizer is added.

CAUTION!

Gasoline stored in the carburetor for extended periods can cause hard starting and could also lead to increased service and maintenance cost.

• Remove the remaining fuel from the fuel lines and carburetor.

1.Prime the primer bulb until no more fuel is passing through.

2.Start and run the engine until it stops running.

3.Repeat steps 1 and 2 until the engine will no longer start.

Remove the spark plug and pour about 1/4 ounce of 2-cycle mixing oil into the cylinder through the spark plug hole. Slowly pull the recoil starter 2 or 3 times so oil will evenly coat the interior of the engine. Reinstall the spark plug.

Before storing the unit, repair or replace any worn or damaged parts.

Remove the air cleaner element from the carburetor and clean it thoroughly with soap and water. Let dry and reassemble the element.

Store the unit in a clean, dust-free area.

18

Image 18
Contents Lawn Edger Contents IntroductionOperational and Warning Labels Work Safely SafetyProduct Description Stay AlertProperly equipped operator Be aware of the working environmentSpecifications TorqueEmission Control exhaust & evaporative AssemblyPrior to assembly Mounting the cutting attachment shield and edger bladeTurn the cable adjuster in or out as Adjust Throttle Trigger Free PlayRemove the air cleaner cover Mixing FuelFilling the fuel tank After useMinimize the Risk of Fire When the Engine Starts Starting the EngineNever start the engine from the operating position Checking Unit Condition Slide the ignition switch toStopping the Engine Starting a Flooded EngineTo adjust blade height Using a hand-held edgerAdjusting blade cutting depth OperationMaintenance Hour Maintenance Direct the air stream at the inside face Filter onlyRemove and replace the fuel filter element With index hole in shaft tube Gearcase lubrication Hour MaintenanceLubricate the Flexible Shaft SecurelyBy a Shindaiwa-trained service technician Valve AdjustmentCarburetor Adjustment Spark Arrester Screen MaintenanceAdjusting Engine Idle Idle Speed AdjustmentReplacing the Edger Blade Long Term Storage Troubleshooting Guide Possible CauseIs the engine overheating? Symptom Possible Cause Remedy Exceptions Purchased Repair Parts and Accessories 01/2010 Page Page Page Servicing Information T13413001001-T13413999999