Shindaiwa 81644 manual Manufacturers Warranty Coverage Limitations

Page 20

The following statement only applies to United States and its territories

Shindaiwa Corporation

Federal Emission Design And Defect Limited Warranty

Utility And Lawn And Garden Engines

Shindaiwa Corporation warrants to the initial purchaser and each subsequent owner, that this utility equipment engine (herein engine) is designed, built and equipped to conform at the time of initial sale, to all applicable regulations of the U.S. Environmental Protection Agency (EPA), and that the engine is free of defects in materials and workmanship that would cause this engine to fail to conform with EPA regulations during its warranty period. This emission warranty is ap- plicable in all States, except the State of California.

For parts listed under PARTS COVERED, the dealer authorized by Shindaiwa Corporation will, at no cost to you, make the necessary diagnosis, repair, or replacement of any defective emission-related component to ensure that the engine complies with applicable U.S. EPA regulations.

MANUFACTURERS WARRANTY COVERAGE

LIMITATIONS

The Federal Emission Design and Defect Warranty shall not cover any of the following:

(a) conditions resulting from tampering, misuse, improper adjustment (unless they were made by the dealer or service center authorized by Shindaiwa Corporation during a warranty repair), alteration, accident, failure to use the recommended fuel and oil, or not performing required maintenance services,

(b) the replacement parts used for required maintenance services,

(c) consequential parts used for required maintenance services,

(d) diagnosis and inspection fees that do not result in eligible war- ranty service being performed, and

(e) any non-authorized replacement part, or malfunction of autho- rized parts due to use of non-authorized parts.

When sold within the U.S., this engine’s emission control system is warranted for a period of two (2) years from the date this product is first delivered to the original retail purchaser.

OWNER’S WARRANTY RESPONSIBILITIES

As the engine owner, you are responsible for the performance of the required maintenance listed in your owner’s manual. Shindaiwa Corporation recom- mends that you retain all receipts covering maintenance on your engine, but Shindaiwa Corporation cannot deny a warranty claim solely for the lack of receipts or for your failure to ensure the performance of all scheduled mainte- nance.

As the engine owner, you should however be aware that Shindaiwa Corpora- tion may deny your warranty coverage if your engine or a part has failed due to abuse, neglect, improper maintenance or unapproved modifications.

You are responsible for presenting your engine to the nearest dealer autho- rized by Shindaiwa Corporation when a problem exists.

If your Shindaiwa Dealer is unable to answer questions regarding your war- ranty rights and responsibilities, you should then contact your Shindaiwa Distributor.

For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time.

MAINTENANCE AND REPAIR REQUIREMENTS

You are responsible for the proper use and maintenance of the engine. You should keep all receipts and maintenance records covering the performance of regular maintenance in the event questions arise. These receipts and mainte- nance records should be transferred to each subsequent owner of the engine. Shindaiwa Corporation reserves the right to deny warranty coverage if the owner has not properly maintained the engine. Shindaiwa Corporation will not deny warranty repairs, however, solely because of the lack of repair, mainte- nance or failure to keep maintenance records.

MAINTENANCE, REPLACEMENT OR REPAIR OF EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY REPAIR ESTAB- LISHMENT OR INDIVIDUAL; HOWEVER, WARRANTY REPAIRS MUST BE PERFORMED BY A DEALER OR SERVICE CENTER AUTHORIZED BY SHINDAIWA CORPORATION THE USE OF PARTS THAT ARE NOT EQUIVA- LENT IN PERFORMANCE AND DURABILITY TO AUTHORIZED PARTS MAY IMPAIR THE EFFECTIVENESS OF THE EMISSION CONTROL SYSTEM AND MAY HAVE A BEARING ON THE OUTCOME OF A WARRANTY CLAIM.

If other than the parts authorized by Shindaiwa Corporation are used for maintenance replacements or for the repair of components affecting emission control, you should assure yourself that such parts are warranted by their manufacturer to be equivalent to the parts authorized by Shindaiwa Corpora- tion in their performance and durability.

PARTS COVERED

Listed below are the parts covered by the Federal Emission Design and Defect Warranty. Some parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement of that part. The war- ranted parts include:

1.Carburetor Internal Components

•Valve Assembly-throttle, Jet, Metering Diaphragm

2.Ignition System Components

•Ignition Coil

•Flywheel Rotor

The emission control system for your particular Shindaiwa engine may also include certain related hoses and connectors.

OBTAINING WARRANTY SERVICE

All repairs qualifying under this limited warranty must be performed by a dealer authorized by Shindaiwa Corporation

If any emission-related part is found defective during the warranty period, it is your responsibility to present the product to an authorized Shindaiwa dealer. Bring your sales receipts showing the date of purchase for this engine. The dealer authorized by Shindaiwa Corporation will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. All parts and accessories replaced under this warranty become the property of Shindaiwa Corporation

To locate an authorized Shindaiwa dealer near you, contact your Shindaiwa Distributor. For the name and telephone number of the Shindaiwa Distributor in your area, please call Shindaiwa Inc. at (503) 692-3070 between the hours of 8:00 AM and 5:00 PM Pacific Standard Time.

THIS WARRANTY IS ADMINISTERED BY

Shindaiwa Inc.

11975 S.W. Herman Rd. Tualatin OR. 97062 (503) 692-3070

Shindaiwa Inc.

Shindaiwa Corporation

11975 S.W. Herman Rd.

6-2-11 Ozuka-Nishi

Tualatin, Oregon 97062

Asaminami-Ku, Hiroshima

Telephone: 503 692-3070

731-3167, Japan

Fax:

503 692-6696

Telephone: 81-82-849-2220

www.shindaiwa.com

Fax:

81-82-849-2481

©2007 Shindaiwa, Inc.

Part Number 81644

Revision 1/07

Shindaiwa is a registered trademark of Shindaiwa, Inc.

Specifications subject to change without notice.

Page 19 Page 21
Image 20
Page 19 Page 21
Contents C242 Brushcutter Introduction ContentsSafety Instructions Properly Equipped Operator Always use the proper cutting tool for the jobSafety Labels Be Aware of the Working EnvironmentProduct Description Specifications C242Prior to Assembly Sub-Shield C242 AssemblyCutting Attachment Shield Adjust Throttle Lever Free Play AdjustmentsHandle Bar C242 Install the handlebar Installing a Trimmer Head With the gear case output shaft facingInstalling a Blade Both holders must be flat against the surface of the bladeMixing Fuel Filling the Fuel TankStarting the Engine Examples of 501 mixing quantitiesAdjusting Engine Idle Cutting attachment may rotate when the engine is startedWhen the Engine Starts Idle Speed AdjustmentCutting Grass-Units equipped with a trimmer head Checking Unit ConditionShoulder Strap C242 Using a Blade C242 Operating Units with a BladeHour Maintenance General MaintenanceDaily Maintenance 10/15-Hour Maintenance Every 10 to 15 hours of operationWith an authorized Shindaiwa servicing DealerLong Term Storage Blade SharpeningShindaiwa Tornado Blade Multiple-tooth Circular BladeTroubleshooting Guide Engine does not StartAdditional Problems Manufacturers Warranty Coverage Limitations 2481-849-82-81 Fax 2220-849-82-81 Telephone 6696-692Japan 3167,-731 3070-692 Hiroshima Ku,-AsaminamiContinuación Diagnostico Guia Adicionales ProblemasDiagnostico Guia 18SPDiscos de Afilado Plazo Largo de AlmacenamientoMúltiples Dientes de Discos Tornado Shindaiwa DiscoMantenimiento horas 135 Cada Shindaiwa autorizado buidorDistri o servicio de centro su con consulte Carbón, de excesiva acumulación nota SiHoras 50 Cada Mantenimiento Horas 10/15 Cada MantenimientoGeneral Mantenimiento Horas 10 Cada MantenimientoDiario Mantenimiento Cuchilla una con Unidades Operando C242 Disco un UsandoUnidad la de Condición la Verifique Corte deCabezal con Equipadas Máquinas Césped de Corte Motor del Mínima Marcha de AjusteMotor del Parada Continuación Motor del ArranqueMotor del Arranque Combustible de Tanque el LlenandoCombustible de Mezcla De proporciónCuchilla la Instalando 9SPNylon de Cabezal del Instalación C242 Mango Continuación EnsamblajeAcelerador del holgura la Ajuste Ajustes Ensamblaje Allen cabezaEnsamblar de Antes C242 EspecificacionesProducto del Descripción Trabajo de Area del Alerta Esté Seguridad de EtiquetasPíes Equipado Debidamente Operario El Seguridad de Instrucciones Limpios mangos los mantenga SiempreContenido Incendios de Riesgo El DisminuyaHumana reproducción la Nocivos efectos otros u congénitos Alerta MantengaseC242 Desmalezadora

81644 specifications

The Shindaiwa 81644 is a remarkable piece of equipment designed for professionals in landscaping and agriculture. Renowned for its durability and performance, this model is an essential tool for anyone in need of a reliable, high-efficiency solution for their yard care and maintenance projects.

One of the standout features of the Shindaiwa 81644 is its powerful engine. The unit is equipped with a robust 25.4 cc 2-stroke engine that delivers an impressive power-to-weight ratio, ensuring efficient operation without compromising on performance. This kind of engine is designed for easy starting and provides a reliable output that allows users to tackle even the most challenging tasks with ease.

Another key characteristic of the Shindaiwa 81644 is its lightweight design. Weighing in at approximately 7.9 lbs, this model is designed to reduce operator fatigue, allowing for extended use without added strain. The ergonomic handle further enhances comfort, enabling a natural grip and offering better control during operation.

Technologically, the Shindaiwa 81644 incorporates advanced anti-vibration technology. This feature minimizes vibrations during use, ensuring a smoother experience while reducing the risk of operator fatigue. Additionally, the unit includes an adjustable throttle, allowing users to optimize their cutting speed based on the specific job at hand.

The durability of the Shindaiwa 81644 is another highlight. Constructed with high-quality materials, this equipment is built to withstand the rigors of regular use in various weather conditions. Its fuel-efficient engine also represents Shindaiwa's commitment to sustainability, minimizing environmental impact while maximizing performance.

For convenience, the Shindaiwa 81644 is designed with an easy-to-access air filter and spark plug, simplifying maintenance. This ensures that operators can keep their equipment in top condition with minimal effort.

In summary, the Shindaiwa 81644 combines power, efficiency, and user-friendly features, making it one of the most sought-after options for professionals looking to enhance their landscaping tools. Whether for commercial or personal use, this model stands out as a reliable choice that meets the demands of any outdoor maintenance project.
Top Page Image Contents